The design of a 2-V 900-MHz CMOS bandpass amplifier
顯示簡易詮釋資料 統計資料| 欄位 | 內容 | 語言 |
|---|---|---|
dc.citation.epage |
210 | en_US |
dc.citation.issue |
3 | en_US |
dc.citation.spage |
197 | en_US |
dc.citation.volume |
27 | en_US |
dc.citation.woscount |
2 | |
dc.contributor.author |
Cheng, Y | en_US |
dc.contributor.author |
Wu, CY | en_US |
dc.contributor.author |
Gong, J | en_US |
dc.contributor.department |
電子工程學系及電子研究所 | zh_TW |
dc.contributor.department |
Department of Electronics Engineering and Institute of Electronics | en_US |
dc.date.accessioned |
2014-12-08T15:44:26Z | |
dc.date.available |
2014-12-08T15:44:26Z | |
dc.date.issued |
2001 | en_US |
dc.description.abstract |
A 900 MHz low-power CMOS bandpass amplifier suitable for the applications of RF front-end in wireless communication receivers is proposed and analyzed. In this design, the temperature compensation circuit is used to stabilize the amplifier gain so that the overall amplifier has a good temperature stability. Moreover, the compact tunable positive-feedback circuit is connected to the integrated spiral inductor to generate the negative resistance and enhance its Q value. The simple diode varactor circuit is adopted for center-frequency tuning. These two improved circuits can reduce the power dissipation of the amplifier. An experimental chip fabricated by 0.5 mum double-poly-double-metal CMOS technology occupies a chip area of 500 x 500 mum(2); chip area. The measured results have verified the performance of the fabricated CMOS bandpass amplifier. Under a 2-V supply voltage, the measured quality factor is tunable between 4.5 and 50 and the tunable frequency range is between 845 MHz and 915 MHz. At Q = 30, the measured S-21 is 20 dB whereas the noise figure is 5.2 dB in the passband. The gain variation is less than 4 dB in the range of 0-80 degreesC. The dc power dissipation is 35 mW. Suitable amplifier gain, low power dissipation, and good temperature stability make the proposed bandpass amplifier quite feasible in RF front-end applications. | en_US |
dc.identifier.issn |
0925-1030 | en_US |
dc.identifier.journal |
ANALOG INTEGRATED CIRCUITS AND SIGNAL PROCESSING | en_US |
dc.identifier.uri |
https://ir.lib.nycu.edu.tw/handle/11536/30013 | |
dc.identifier.wosnumber |
WOS:000168389000003 | |
dc.language.iso |
en_US | en_US |
dc.subject |
tunable bandpass amplifier | en_US |
dc.subject |
bandpass filter | en_US |
dc.subject |
CMOS technology | en_US |
dc.subject |
integrated inductor | en_US |
dc.subject |
temperature stability | en_US |
dc.subject |
low power dissipation | en_US |
dc.subject |
mobile communication | en_US |
dc.subject |
radio frequency | en_US |
dc.subject |
RF front-end circuit | en_US |
dc.subject |
wireless receiver | en_US |
dc.title |
The design of a 2-V 900-MHz CMOS bandpass amplifier | en_US |
dc.type |
Article | en_US |
檔案
本條目沒有附加檔案。
所屬典藏: 期刊論文
引用此條目
Cheng, Y., Wu, C., & Gong, J. (2001). The design of a 2-V 900-MHz CMOS bandpass amplifier. ANALOG INTEGRATED CIRCUITS AND SIGNAL PROCESSING, 27(3), 197–210. https://ir.lib.nycu.edu.tw/handle/11536/30013
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/30013