A CMOS 6-Bit 16-GS/s Time-Interleaved ADC Using Digital Background Calibration Techniques
顯示簡易詮釋資料 統計資料| 欄位 | 內容 | 語言 |
|---|---|---|
dc.citation.epage |
858 | en_US |
dc.citation.issue |
4 | en_US |
dc.citation.spage |
848 | en_US |
dc.citation.volume |
46 | en_US |
dc.citation.woscount |
29 | |
dc.contributor.author |
Huang, Chun-Cheng | en_US |
dc.contributor.author |
Wang, Chung-Yi | en_US |
dc.contributor.author |
Wu, Jieh-Tsorng | en_US |
dc.contributor.department |
電子工程學系及電子研究所 | zh_TW |
dc.contributor.department |
Department of Electronics Engineering and Institute of Electronics | en_US |
dc.date.accessioned |
2014-12-08T15:11:50Z | |
dc.date.available |
2014-12-08T15:11:50Z | |
dc.date.issued |
2011-04-01 | en_US |
dc.description.abstract |
An 8-channel 6-bit 16-GS/s time-interleaved analog-to-digital converter (TI ADC) was fabricated using a 65 nm CMOS technology. Each analog-to-digital channel is a 6-bit flash ADC. Its comparators are latches without the preamplifiers. The input-referred offsets of the latches are reduced by digital offset calibration. The TI ADC includes a multi-phase clock generator that uses a delay-locked loop to generate 8 sampling clocks from a reference clock of the same frequency. The uniformity of the sampling intervals is ensured by digital timing-skew calibration. Both the offset calibration and the timing-skew calibration run continuously in the background. At 16 GS/s sampling rate, this ADC chip achieves a signal-to-distortion-plus-noise ratio (SNDR) of 30.8 dB. The chip consumes 435 mW from a 1.5 V supply. The ADC active area is 0.93 x 1.58 mm(2). | en_US |
dc.identifier.doi |
10.1109/JSSC.2011.2109511 | en_US |
dc.identifier.issn |
0018-9200 | en_US |
dc.identifier.journal |
IEEE JOURNAL OF SOLID-STATE CIRCUITS | en_US |
dc.identifier.uri |
http://dx.doi.org/10.1109/JSSC.2011.2109511 | en_US |
dc.identifier.uri |
https://ir.lib.nycu.edu.tw/handle/11536/9084 | |
dc.identifier.wosnumber |
WOS:000288762800014 | |
dc.language.iso |
en_US | en_US |
dc.subject |
Analog-digital conversion | en_US |
dc.subject |
calibration | en_US |
dc.subject |
clocks | en_US |
dc.subject |
comparators | en_US |
dc.subject |
flash ADC | en_US |
dc.subject |
offset | en_US |
dc.subject |
time-interleaved ADC | en_US |
dc.subject |
time interleaving | en_US |
dc.subject |
timing circuits | en_US |
dc.subject |
timing skew | en_US |
dc.title |
A CMOS 6-Bit 16-GS/s Time-Interleaved ADC Using Digital Background Calibration Techniques | en_US |
dc.type |
Article | en_US |
檔案
- 000288762800014.pdf (632.6 KB, Adobe PDF)
所屬典藏: 期刊論文
引用此條目
Huang, C.-C., Wang, C.-Y., & Wu, J.-T. (2011). A CMOS 6-Bit 16-GS/s Time-Interleaved ADC Using Digital Background Calibration Techniques. IEEE JOURNAL OF SOLID-STATE CIRCUITS, 46(4), 848–858. https://doi.org/10.1109/JSSC.2011.2109511
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/9084