Fabrication of PDMS (polydimethylsiloxane) microlens and diffuser using replica molding

檔案

日期

2006-11-01

類型

期刊名稱

MICROELECTRONIC ENGINEERING

卷期與頁次

第 83 卷第 11-12 期,頁 2499–2503

ISSN

0167-9317

語言

英文

摘要

This paper reports the fabrication method of PDMS (polydimethylsiloxane) microlens array based on the replica molding process, casting a liquid PDMS into concave microlens molds. Concave microlens molds were fabricated through spin-coating processes suspended a liquid PMMA film on the micro-drilled hole, leading to the formation of the special curvature. Then, PDMS microlens arrays and diffusers were fabricated by replica molding and discussed in this study. The fabricated microlenses have both good surface roughness and high-quality optical properties. Therefore, diffusers were fabricated by two-step replica molding. A high-intensity He-Ne laser beam was uniformly spread through diffusers. Experimental tests demonstrated that all PDMS elements are successfully fabricated by replica molding process and operated during optical measurement. (c) 2006 Elsevier B.V. All rights reserved.

所屬典藏

期刊論文
顯示完整詮釋資料 統計資料

引用此條目

Shih, T.-K., Chen, C.-F., Ho, J.-R., & Chuang, F.-T. (2006). Fabrication of PDMS (polydimethylsiloxane) microlens and diffuser using replica molding. MICROELECTRONIC ENGINEERING, 83(11-12), 2499–2503. https://doi.org/10.1016/j.mee.2006.05.006

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/11561