Dry sliding wear behaviors of Al-25Si-2.5Cu-1Mg alloys prepared by powder thixocasting

檔案

日期

2005-04-25

類型

期刊名稱

MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING

卷期與頁次

第 397 卷第 1-2 期,頁 178–189

ISSN

0921-5093

語言

英文

摘要

The wear performance of an Al-25Si-2.5Cu-1Mg alloy prepared by powder thixocasting was studied using a pin-on-disc machine. LM13 and an Al-25Si-2.5Cu-lMg alloy prepared by conventional ingot metallurgy were also investigated for comparison. The sliding tests were performed under ambient conditions and without lubricant. During the tests, the applied load was increased stepwise until wear seizure occurred. Experimental data reveal that the powder thixocast alloys exhibit better wear performance than that of conventional alloys, especially under heavy load conditions and following T6 treatment. This work demonstrates the potential of the new method, powder thixocasting, for fabricating hypereutectic Al-Si-X alloys with a high wear resistance. Moreover, the variation in the wear rate with the applied load for the alloy can be divided into three regions. The mechanisms associated with these wear regions were discussed based on the investigations of the worn subsurface and the wear debris. (c) 2005 Elsevier B.V. All rights reserved.

所屬典藏

期刊論文
顯示完整詮釋資料 統計資料

引用此條目

Chen, C., Yang, C., & Chao, C. (2005). Dry sliding wear behaviors of Al-25Si-2.5Cu-1Mg alloys prepared by powder thixocasting. MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 397(1-2), 178–189. https://doi.org/10.1016/j.msea.2005.02.010

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/13800