Interfacial Investigation on Printable Carbon-Based Mesoscopic Perovskite Solar Cells with NiOx/C Back Electrode
檔案
本條目沒有附加檔案。
日期
2017-08-02
類型
期刊名稱
ACS APPLIED MATERIALS & INTERFACES
卷期與頁次
第 9 卷,頁 25204–25215
ISSN
1944-8244
語言
英文
摘要
Solar cells with high efficiency, low cost, and high stability are the target for the new generation of solar cells. A fully printable perovskite (CH3NH3PbI3) solar cell (PSC) with device architecture FTO/TiO2/Al2O3/NiOx/C is fabricated in the current research as a low-cost and relatively stable structure and is investigated to determine how different fabrication factors such as the thickness of the insulating spacer layer (Al2O3) or treatments such as heat and UV-O-3 treatments can affect the interfacial properties of this multilayer mesoporous structure. X-ray photoelectron spectra (XPS) show that UV-O-3 treatment increases the Ni3+ (Ni2O3) phase on the surface of the black nickel oxide layer leading to better charge extraction and increasing open-circuit voltage (V-OC) up to 0.945 V. We observe improved CH3NH3PbI3 formation inside the mesoporous layers by the PbI2 penetration at a higher temperature. Impedance spectral together with current-voltage measurements show the effect of thickness for the insulator layer in the internal and interfacial resistances and photovoltaic characteristics of the cell. The best performance of the carbon-based PSC attains power conversion efficiency of 12.1% with the thickness of the Al2O3 layer at 450 nm.
關鍵詞
perovskite-based solar cellsinorganic hole-transporting materialUV-O-3 treatmentimpedance spectroscopyopen-circuit voltagework function所屬典藏
期刊論文引用此條目
Behrouznejad, F., Tsai, C.-M., Narra, S., Diau, E. W. G., & Taghavinia, N. (2017). Interfacial Investigation on Printable Carbon-Based Mesoscopic Perovskite Solar Cells with NiOx/C Back Electrode. ACS APPLIED MATERIALS & INTERFACES, 9, 25204–25215. https://doi.org/10.1021/acsami.7b02799
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/145877