Modification on surface roughness by combining dry and wet etching

檔案

日期

2003

期刊名稱

SMART SENSORS, ACTUATORS, AND MEMS, PTS 1 AND 2

卷期與頁次

第 5116 卷,頁 627–635

ISSN

0277-786X

ISBN

0-8194-4976-8

語言

英文

摘要

The materials owning the rough surface have been adopted in many applications, such as MEMS devices, solar cell, DRAM, and so on. However, the modified targets on the previous methods were almost limited to silicon-type materials, and some had the limitations in the material properties. Recently, a process combining spin-on photoresist and one-step RIE was proposed to modify various materials, which can be etched by RIE. Here, a modification process, which combines spin-on photoresist, two-step RIE, and wet etching, is proposed to extend the feasible materials to be modified, because more materials can be etched by chemical solutions. Also, it is a low temperature process, and no extra mask is needed. From the experimental results, the modified surface can be used to alleviate stiction of microstructures, and a detachment length is found to be about 2.2 times longer than the cantilevers without the modified surface. Moreover, the related parameters for the anti-stiction are also developed, and the effects are compared with the previously developed one-step RIE method.

所屬典藏

會議論文
顯示完整詮釋資料 統計資料

引用此條目

Lee, C., & Hsu, W. (2003). Modification on surface roughness by combining dry and wet etching. SMART SENSORS, ACTUATORS, AND MEMS, PTS 1 AND 2, 5116, 627–635. https://doi.org/10.1117/12.498918

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/18500