Fabrication of high-aspect-ratio ceramic microstructures by injection molding with the altered lost mold technique
檔案
- 000167502000013.pdf (143.1 KB, Adobe PDF)
日期
2001-03-01
類型
系所
期刊名稱
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS
卷期與頁次
第 10 卷第 1 期,頁 62–68
ISSN
1057-7157
語言
英文
摘要
A fabrication process for complex ceramic microstructures was proposed that combines a lost mold technique and ceramic injection molding. Two key points in this process were studied. First, the solubility of several engineering plastics in various organic solvents was tested to find appropriate combinations of mold material and solvent for dissolving molds, Secondly, the binder extraction rate and the strength of a green body during debinding were investigated. Experimental results indicate that acrylonitrile-butadiene styrene and acetone are the best combinations selected for this lost mold technique. We also propose that using gasoline as the debinding solvent and performing the debinding at room temperature mill give a good time-saving effect and avoid toppling the microstructure if paraffin wax, stearic acid, and polyethylene were selected to compound the binder system. This process has been successfully applied to fabricate several ceramic microstructures, such as integrated punch.
關鍵詞
ceramic injection moldingceramic microstructureextraction ratelost mold techniquesolubilitytoppling所屬典藏
期刊論文引用此條目
Chen, R., & Lan, C. (2001). Fabrication of high-aspect-ratio ceramic microstructures by injection molding with the altered lost mold technique. JOURNAL OF MICROELECTROMECHANICAL SYSTEMS, 10(1), 62–68. https://doi.org/10.1109/84.911093
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/29816