Browsing by Author "Chang, Chi-Shin"

Now showing 1 - 4 of 4

A 40nm 1.0Mb 6T Pipeline SRAM with Digital-Based Bit-Line Under-Drive, Three-Step-Up Word-Line, Adaptive Data-Aware Write-Assist with VCS Tracking and Adaptive Voltage Detector for Boosting Control
(2013-01-01)
Liao, Wei-Nan
;
Lien, Nan-Chun
;
Chang, Chi-Shin
;
Chu, Li-Wei
;
Yang, Hao-I
This paper presents a 40nm 1.0Mb pipeline 6T SRAM featuring digital-based Bit-Line Under-Drive (BLUD) with large-signal sensing and Three-Step-Up Word-Line (TSUWL) to improve RSNM, Read performance and Write-ability. An Adaptive DataAware Write-Assist (ADAWA) with VCS tracking is employed to further improve Write-ability while ensuring adequate stability for half-selected cells on the selected bit-lines. An Adaptive Voltage Detector (AVD) with binary boosting control is used to mitigate gate dielectric over-stress. The 1.0Mb test chip operates from 1.5V to 0.7V, with operating frequency of 1.07GHz@1.2V and 887MHz@1.1V at 25 degrees C. The measured power consumption is 43.47mW (Active)/3.91mW (Leakage) at 1.1V and 8.97mW (Active)/0.52mW (Leakage) at 0.7V, TT, 25 degrees C.
A 40nm 1.0Mb Pipeline 6T SRAM with Variation-Tolerant Step-Up Word-Line and Adaptive Data-Aware Write-Assist
(2013)
Chang, Chi-Shin
;
Yang, Hao-I
;
Liao, Wei-Nan
;
Lin, Yi-Wei
;
Lien, Nan-Chun
We present a 1.0Mb pipeline 6T SRAM in 40nm Low-Power CMOS technology. The design employs a variation-tolerant Step-Up Word-Line (SUWL) to improve the Read Static Noise Margin (RSNM) without compromising the Read performance and Write-ability. The Write-ability is further enhanced by an Adaptive Data-Aware Write-Assist (ADAWA) scheme. The 1.0Mb test chip operates from 1.5V to 0.7V, with operating frequency of 800MHz@1.2V and 25 degrees C. The measured power consumption is 23.21mW (Active)/2.42mW (Leakage) at 1.2V, TT, 25 degrees C; and 6.01mW (Active)/0.35mW (Leakage) at 0.7V, TT, 25 degrees C.
A High-Performance Low V(MIN) 55nm 512Kb Disturb-Free 8T SRAM with Adaptive VVSS Control
(2011)
Yang, Hao-I
;
Yang, Shih-Chi
;
Hsia, Mao-Chih
;
Lin, Yung-Wei
;
Lin, Yi-Wei
This paper describes a high-performance low V(MIN) SRAM with a disturb-free 8T cell. The SRAM utilizes single-ended buffer Read, and cross-point data-aware Write Word-Line structure with adaptive VVSS control to eliminate Read disturb and Half-Select disturb, thus facilitating bit-interleaving architecture and achieving low V(MIN). A 512Kb test chip is implemented in UMC 55nm Standard Performance (SP) CMOS technology. The measurement results demonstrate operating frequency of 943MHz at 1.2V VDD and 209MHz at 0.6V VDD.
High-Performance 0.6V V-MIN 55nm 1.0Mb 6T SRAM with Adaptive BL Bleeder
(2012)
Yang, Hao-I
;
Lin, Yi-Wei
;
Hsia, Mao-Chih
;
Lin, Geng-Cing
;
Chang, Chi-Shin
This paper presents a 1.0Mb high-performance 0.6V V-MIN 6T SRAM design implemented in UMC 55nm Standard Performance (SP) CMOS technology. This design utilizes an adaptive LBL bleeder technique to reduce Read disturb and Half-Select disturb of 6T cells while maintaining adequate sensing margin. A bleeder timing control circuit adaptively adjusts the LBL voltage level prior to Read/Write operation to facilitate wide operation voltage range. Hierarchical WL, hierarchical BL, and distributed replica timing control scheme are used to improve SRAM performance. Based on measurement results, the SRAM operates from 1.5V down to 0.6V. The maximum operating frequency is 1.517GHz@1.5V and 469MHz@0.7V.