Browsing by Author "Chang, LH"

Now showing 1 - 2 of 2

Performances and characteristics of a prototype symmetric hybrid adjustable phase undulator
(1997-11-11)
Hwang, CS
;
Chang, CH
;
Fan, TC
;
Lin, FY
;
Wang, C
In this work, we construct and measure a prototype symmetric Hybrid Adjustable Phase Undulator (HAPU) with nine poles to compare phase change and gap change in terms of their features and performances. HAPU can also provide the different characteristics between the pure and hybrid adjustable phase undulator. The HAPU has been installed in the Synchrotron Radiation Research Center (SRRC) storage ring to test the performance of the beam dynamics and photon flux behavior. A three-orthogonal Hall probe and a long-loop-coil measurement system are also implemented to take the field measurements. The multipole field and electron trajectory correction are made by shimming, the magic finger, and the active end pole coil corrector. After the field measurements, the vertical integral strength of HAPU is markedly smaller than that of the Hybrid Adjustable Gap Undulator (HAGU) and confirm that no obvious distinction arises between HAPU and HAGU in terms of the spectrum flux. The electron beam dynamic performance in the storage ring indicates that the vertical tune shift of HAPU is three times smaller than that of HAGU. Meanwhile, the energy dynamic tuning with the digital global feedback turned on, the photon position and flux in the bending chamber beam line is invariant. In addition, the injection efficiency remains unaffected at any phase position and the electron beam lifetime does not change when HAPU is in the dynamic tuning.
The construction of a 9-pole prototype for SRRC U-10 undulator
(1996-07-01)
Chang, CH
;
Chang, LH
;
Chen, HH
;
Fan, TC
;
Hwang, CS
A 9-pole undulator prototype with a magnetic period length of 10 cm was designed and constructed to examine the mechanical and magnetic field performance. The hybrid permanent magnet structure was optimized by using 2D ''PANDIRA'' and 3D ''TOSCA'' magnetostatic codes. A half period magnet model was also fabricated to verify the magnetic Period length field strength on-axis and the transverse field roll-off within 0.1 % in the good field region of +/- 10 mm at a minimum gap of 22 mm. The end pole configurations, as equipped with either two tunable permanent magnetic rotators or steering coil correctors were designed for minimizing the deviation of the magnetic field strength integrals. The magnet structures were mounted bn a 2 meter long C-frame support structure in which the gap could be moved in parallel and phase motion. The field characteristics, and measurement results between the adjustable gap undulator (AGO) and the hybrid adjustable phase undulator (APU) were also presented.