Browsing by Author "Chen, Miao-Ru"

Now showing 1 - 2 of 2

Comparison of the Trilateral Flash Cycle and Rankine Cycle with Organic Fluid Using the Pinch Point Temperature
(2019-12-01)
Lai, Kai-Yuan
;
Lee, Yu-Tang
;
Chen, Miao-Ru
;
Liu, Yao-Hsien
;
機械工程學系
Low-temperature heat utilization can be applied to waste heat from industrial processes or renewable energy sources such as geothermal and ocean energy. The most common low-temperature waste-heat recovery technology is the organic Rankine cycle (ORC). However, the phase change of ORC working fluid for the heat extraction process causes a pinch-point problem, and the heat recovery cannot be efficiently used. To improve heat extraction and power generation, this study explored the cycle characteristics of the trilateral flash cycle (TFC) in a low-temperature heat source. A pinch-point-based methodology was developed for studying the optimal design point and operating conditions and for optimizing working fluid evaporation temperature and mass flow rate. According to the simulation results, the TFC system can recover more waste heat than ORC under the same operating conditions. The net power output of the TFC was approximately 30% higher than ORC but at a cost of higher pump power consumption. Additionally, the TFC was superior to ORC with an extremely low-temperature heat source (<80 degrees C), and the ideal efficiency was approximately 3% at the highest work output condition. The TFC system is economically beneficial for waste-heat recovery for low-temperature heat sources.
Experiments for suitability of plastic heat exchangers for dehumidification applications
(2019-07-25)
Amer, Mohammed
;
Chen, Miao-Ru
;
Sajjad, Uzair
;
Ali, Hafiz Muhammad
;
Abbas, Naseem
The present study conducted a series of experiments concerning the condensation of humid air used in a typical adsorption dehumidifier. The experiments were carried out with the standard ambient condition (27 degrees C dry bulb temperature and 21.2 degrees C wet bulb temperature) for the cold side. Yet the regeneration side (hot side) inlet temperature is 55 degrees C with RH% being 100%. Three novel plastic heat exchangers (plate plastic heat exchanger-PHX, bare tube plastic heat exchanger with asymmetry tube layout-BTHX, and round tube plastic heat exchanger with uniform tube layout-RTHX) were tested and compared experimentally. Test results, in terms of heat flux or heat transfer coefficient, show that the BTHX is superior to RTHX and PHX for offering additional condensate splashing mode. The splashing feature is especially beneficial for larger cold side flow rate since the plateau of heat transfer performance is moved toward larger cold side flow rate regime. The asymmetry tube geometry design (BTHX) shows even better heat transfer performance than the uniform tube bundle design (RTHX) for providing more space at the downstream of the tube bundle.