Browsing by Author "Fang, WL"

Now showing 1 - 2 of 2

MEMS-based miniature optical pickup
(2005-02-01)
Chiu, Y
;
Chen, CH
;
Chiou, JC
;
Fang, WL
;
Shieh, HPD
The technology challenges for miniature optical pickups include high-numerical-aperture objective lens design, servo actuator functions and performance, and component assembly tolerance. In this paper, a microelectromechanical systems (MEMS)-based miniature optical pickup is proposed for DVD and blue disk systems. A high-order diffractive objective lens with a continuous surface relief is designed. Focus, tilt, and tracking servos are implanted with MEMS micro actuators. Preliminary design and test results are presented.
Ni-carbon nanotubes nanocomposite for robust microelectromechanical systems fabrication
(2006-01-01)
Tsai, LN
;
Cheng, YT
;
Hsu, WS
;
Fang, WL
;
電子工程學系及電子研究所
This article presents a novel fabrication process to enhance the operational performance and reliability of electrothermal microactuators. Carbon nanotubes (CNTs) (outer diameter: 10-20 nm, innerdiameter: 5-10 nm, length: 0.5-200 mu m) are incorporated in an electrolytic nickel deposition process in which a well-dispersed Ni-CNTs colloidal solution is made by a special acid oxidative method to synthesis a Ni-CNTs nanocomposite for device fabrication. Measurement results show that the microactuator plated with CNTs (0.028 g/L) needs the power requirement less 95% than the pure nickel device at the same output displacement of 3 mu m. The performance improvement of the electrothermal microactuator made of the nanocomposite, including device strength and power efficiency, has shown to be similar to the Ni-diamond composites (L. N. Tsai, G. R. Shen, Y. T. Cheng, and W. S. Hsu, The 54th Electronic Components and Technology Conference, June 2004, pp. 472-476)). In addition, the E/p ratio of the Ni-CNTs composite can be enhanced to 1.47 times higher than that of pure nickel, which is a fascinating result for resonant device fabrication. (c) 2006 American Vacuum Society.