Browsing by Author "Hu, Yin-Chu"

Now showing 1 - 2 of 2

Design of Flip-Chip Interconnect Using Epoxy-Based Underfill Up to V-Band Frequencies With Excellent Reliability
(2010-08-01)
Hsu, Li-Han
;
Wu, Wei-Cheng
;
Chang, Edward Yi
;
Zirath, Herbert
;
Hu, Yin-Chu
This study demonstrates a flip-chip interconnect with epoxy-based underfill (epsilon(r) = 3.5 and tan delta = 0.02 at 10 MHz) for packaging applications up to V-band frequencies. To achieve the best interconnect performance, both the matching designs on GaAs chip and Al(2)O(3) substrate were adopted with the underfill effects taken into consideration. The optimized flip-chip interconnect showed excellent performance from dc to 67 GHz with return loss below -20 dB and insertion loss less than 0.6 dB. Furthermore, the dielectric loss induced by the underfill was extracted from measurement and compared with the simulation results. The reliability tests including 85 degrees C/85 % relative humidity test, thermal cycling test, and shear force test were performed. For the first time, the S-parameters measurement was performed to check the flip-chip reliability, and no performance decay was observed after 1000 thermal cycles. Moreover, the mechanical strength was improved about 12 times after the underfill was applied. The results show that the proposed flip-chip architecture has excellent reliability and can be applied for commercial applications.
Investigation of the Flip-Chip Package With BCB Underfill for W-Band Applications
(2014-01-01)
Wang, Chin-Te
;
Hsu, Li-Han
;
Wu, Wei-Cheng
;
Hsu, Heng-Tung
;
Chang, Edward Yi
Flip-chip package has great potential for use in millimeter-wave applications. However, the coefficient of thermal expansion mismatch between the chip and the substrate usually generates thermal stresses that fracture the flip-chip structure. The use of underfills with low dielectric loss is essential to improve the mechanical strength and reliability of the flip-chip package. Benzocyclobutene (BCB) was used in this study as the underfill material for the flip-chip structure using the no-flow process. The flip-chip structure with BCB injection provides good RF performance with a return loss of better than 18 dB and an insertion loss of 0.6 dB up to 100 GHz, in addition to a lower dielectric loss. Furthermore, thermal cycle and shear force tests show that the underfill injection can significantly improve the reliability of a flip-chip package.