Browsing by Author "Lin, Jenn Der"

Now showing 1 - 2 of 2

Crosswise ridge micromixers with split and recombination helical flows
(2011-05-15)
Chen, Jyh Jian
;
Lai, Yu Ren
;
Tsai, Rei Tang
;
Lin, Jenn Der
;
Wu, Chih Yang
This study presents a novel crosswise ridge micromixer (CRM) with a series of microstructures placed on the top and bottom floors of channels. Passive micromixers fabricated by Micro Electro-Mechanical Systems (MEMS) technologies with slanted ridges are investigated. Numerical simulations and experimental investigations are undertaken to determine the effects of various microstructure patterns on mixing efficiency with Reynolds numbers (Re) of 0.05-50. The confocal images at the cross-sections along the channel with ridges on both the channel top and bottom are first investigated in our study. A significant amount of split and recombination (SAR) helical flows is produced by the slanted ridges embedded on the two floors of the channels. The effects of non-dimensional parameters, such as the Re, as well as geometrical parameters on mixing performance are presented in terms of the mixing index. When the Re exceeds 1, the mixing index of the micromixer with slanted ridges increases as the Re increases further. Simulation results are presented and compared with experimental data. The trends of the experimental results and numerical data are very similar. Finally, various numbers of slanted ridges in the same orientation in one channel cycle are investigated to determine mixing performance in microchannels. The mixing performance achieves an optimum value in case where the number of ridges per cycle is equal to 8. (C) 2011 Elsevier Ltd. All rights reserved.
Surface Tension Flows inside Surfactant-Added Poly(dimethylsiloxane) Microstructures with Velocity-Dependent Contact Angles
(2014-06-01)
Chen, Jyh Jian
;
Liao, Shih Chuan
;
Liu, Mao Hsun
;
Lin, Jenn Der
;
Sheu, Tsung Sheng
Filling of liquid samples is realized in a microfluidic device with applications including analytical systems, biomedical devices, and systems for fundamental research. The filling of a disk-shaped polydimethylsiloxane (PDMS) microchamber by liquid is analyzed with reference to microstructures with inlets and outlets. The microstructures are fabricated using a PDMS molding process with an SU-8 mold. During the filling, the motion of the gas-liquid interface is determined by the competition among inertia, adhesion, and surface tension. A single ramp model with velocity-dependent contact angles is implemented for the accurate calculation of surface tension forces in a three-dimensional volume-of-fluid based model. The effects of the parameters of this functional form are investigated. The influences of non-dimensional parameters, such as the Reynolds number and the Weber number, both determined by the inlet velocity, on the flow characteristics are also examined. An oxygen-plasma-treated PDMS substrate is utilized, and the microstructure is modified to be hydrophilic. Flow experiments are conducted into both hydrophilic and hydrophobic PDMS microstructures. Under a hydrophobic wall condition, numerical simulations with imposed boundary conditions of static and dynamic contact angles can successfully predict the moving of the meniscus compared with experimental measurements. However, for a hydrophilic wall, accurate agreement between numerical and experimental results is obvious as the dynamic contact angles were implemented.