Browsing by Author "Lin, Yuh-Jiun"

Now showing 1 - 2 of 2

A 0.33-V, 500-kHz, 3.94-mu W 40-nm 72-Kb 9T Subthreshold SRAM With Ripple Bit-Line Structure and Negative Bit-Line Write-Assist
(2012-12-01)
Lu, Chien-Yu
;
Tu, Ming-Hsien
;
Yang, Hao-I
;
Wu, Ya-Ping
;
Huang, Huan-Shun
This paper presents an ultra-low-power 72-Kb 9T static random-access memory (SRAM) with a ripple bit-line (RPBL) structure and negative bit-line (NBL) write-assist. The RPBL scheme provides over 40% read access performance improvement for VDD below 0.4 V compared with the conventional hierarchical bit-line structure. A variation-tolerant ripple-initiated NBL write-assist scheme with the transient negative pulse coupled only into the single selected local bit-line segment is employed to enhance the NBL, boosting efficiency and reducing power consumption. The 331 x 385 mu m(2) 72-Kb SRAM macro has been fabricated in UMC 40-nm low-power CMOS technology and was tested with full suites of SRAM compiler qualification patterns. Error-free full functionality without redundancy is achieved from 1.5 V down to 0.33 V. The measured maximum operation frequency is 220 MHz (500 kHz) at 1.1 V (0.33 V) and 25 degrees C. The measured total power consumption is 3.94 mu W at 0.33 V, 500 kHz, and 25 degrees C.
A Single-Ended Disturb-Free 9T Subthreshold SRAM With Cross-Point Data-Aware Write Word-Line Structure, Negative Bit-Line, and Adaptive Read Operation Timing Tracing
(2012-06-01)
Tu, Ming-Hsien
;
Lin, Jihi-Yu
;
Tsai, Ming-Chien
;
Lu, Chien-Yu
;
Lin, Yuh-Jiun
This paper presents a novel single-ended disturb-free 9T subthreshold SRAM cell with cross-point data-aware Write word-line structure. The disturb-free feature facilitates bit-inter-leaving architecture, which can reduce multiple-bit upsets in a single word and enhance soft error immunity by employing Error Checking and Correction (ECC) technique. The proposed 9T SRAM cell is demonstrated by a 72 Kb SRAM macro with a Negative Bit-Line (NBL) Write-assist and an adaptive Read operation timing tracing circuit implemented in 65 nm low-leakage CMOS technology. Measured full Read and Write functionality is error free with V-DD down to 0.35 V (similar to 0.15 V lower than the threshold voltage) with 229 KHz frequency and 4.05 mu W power. Data is held down to 0.275 V with 2.29 mu W Standby power. The minimum energy per operation is 4.5 pJ at 0.5 V. The 72 Kb SRAM macro has wide operation range from 1.2 V down to 0.35 V, with operating frequency of around 200 MHz for V-DD around/above 1.0 V.