Browsing by Author "Lu, Yu-Lun"

Now showing 1 - 8 of 8

3D 65nm CMOS with 320 degrees C Microwave Dopant Activation
(2009)
Lee, Yao-Jen
;
Lu, Yu-Lun
;
Hsueh, Fu-Kuo
;
Huang, Kuo-Chin
;
Wan, Chia-Chen
For the first time, CMOS TFTs of 65nm channel length have been demonstrated by using a novel microwave dopant activation technique. A low temperature microwave anneal is. demonstrated and discussed in this study. We have successfully activated the poly-Si gate electrode and source/drain junctions, BF2 for p-MOS TFTs and P-31 for n-MOS TFTs at a low temperature of 320 degrees C without diffusion. The technology is promising for high performance and low cost upper layer nanometer-scale transistors as required by low temperature 3D-ICs fabrication.
High Tensile Stress with Minimal Dopant Diffusion by Low Temperature Microwave Anneal
(2011)
Lee, Yao-Jen
;
Lu, Yu-Lun
;
Mu, Zheng-Chang
;
Hsueh, Fu-Kuo
;
Chao, Tien-Sheng
In this letter, rapid thermal annealing (RTA) and microwave annealing (MA) are compared to demonstrate the dopant activation. Using microwave annealing, the dopant in the Si was well-activated and showed suppressed dopant diffusion, as compared to traditional high temperature RTA. In addition, SiN(x) films after low temperature MA treatment presented higher tensile stress than the films annealed by RTA. Therefore, this MA approach could potentially be applied to these behaviors of I distribution and higher tensile stress SiNx film may be useful in contact etch-stop layer or stress memorization technique in the fabrication of small pitch nanoscaled n-channel Metal-Oxide-Semiconductor Field Effect Transistors. (C) 2011 The Electrochemical Society. [DOI: 10.1149/1.3536462] All rights reserved.
Low-Temperature Microwave Annealing Processes for Future IC Fabrication-A Review
(2014-03-01)
Lee, Yao-Jen
;
Cho, Ta-Chun
;
Chuang, Shang-Shiun
;
Hsueh, Fu-Kuo
;
Lu, Yu-Lun
Microwave annealing (MWA) and rapid thermal annealing (RTA) of dopants in implanted Si are compared in their abilities to produce very shallow and highly activated junctions. First, arsenic (As), phosphorus (P), and BF2 implants in Si substrate were annealed by MWA at temperatures below 550 degrees C. Next, enhancing the substitutional carbon concentration ([C] sub) by cluster carbon implantation in (100) Si substrates with MWA or RTA techniques was investigated. Annealing temperatures and time effects were studied. Different formation mechanisms of SiCx layer were observed. In addition, substrate temperature is an important factor for dopant activation during MWA and in situ doped a-Si on oxide/Si substrate or glass were compared to elucidate the substrate temperature effect. After the discussion of dopant activation in Si substrates, low temperature formation of ultrathin NiGe layer is presented. Ultrathin NiGe films with low sheet resistance have been demonstrated with a novel two-step MWA process. In the two-step MWA process, the first step anneals the sample with low power MWA, and the second step applies higher power MWA for reducing sheet resistance. During fixed-frequency microwave heating, standing wave patterns may be present in the MWA chamber resulting in nodes and antinodes and thermal variations over the process wafer. Therefore, the effects of Si or quartz susceptor wafers on dopant activation and sheet resistance uniformity during fixed-frequency MWA were investigated.
Microwave Annealing of Phosphorus and Cluster Carbon Implanted (100) and (110) Si
(2013)
Cho, Ta-Chun
;
Lu, Yu-Lun
;
Yao, Jie-Yi
;
Lee, Yao-Jen
;
Sekar, Karuppanan
Effects of low-temperature (approximate to 500 degrees C) microwave annealing (MWA) of Cluster-Carbon (C-7) and Phosphorus implants are compared with rapid thermal annealing (RTA) at 900 and 1000 degrees C for (100) and (110)-Si substrates. MWA annealing resulted in high levels of substitutional Carbon, 1.57% for (100) Si and 0.99% for (110) Si for C-7 implants. Addition of high-dose Phosphorus implants resulted in lower but still useful substitutional Carbon levels, 1.44% for (100) Si and 0.68% for (110) Si after MWA. RTA annealing at higher temperatures resulted in greatly reduced substitutional Carbon levels and deeper Phosphorus junctions. The effects of subsequent anneals by MWA and RTA methods are reported. MWA is shown to be a promising method for high-channel tensile strain in nMOSFETs with a substantially lower thermal budget than RTA. (C) 2013 The Electrochemical Society. All rights reserved.
Nanoscale p-MOS Thin-Film Transistor With TiN Gate Electrode Fabricated by Low-Temperature Microwave Dopant Activation
(2010-05-01)
Lu, Yu-Lun
;
Hsueh, Fu-Kuo
;
Huang, Kuo-Ching
;
Cheng, Tz-Yen
;
Kowalski, Jeff M.
In this letter, nanoscale p-MOS TFTs with a TiN gate electrode were realized using a novel microwave (MW) dopant-activation technique. We compared both low-temperature MW annealing and rapid thermal annealing. We successfully activated the source/drain region and suppressed the short-channel effects using low-temperature MW annealing. This technique is promising from the viewpoint of realizing high-performance and low-cost upper layer nanoscale transistors required for low-temperature 3-D integrated circuit fabrication.
Novel 2-Bit/Cell Wrapped-Select-Gate SONOS TFT Memory Using Source-Side Injection for NOR-Type Flash Array
(2012-06-01)
Wang, Kuan-Ti
;
Hsueh, Fang-Chang
;
Lu, Yu-Lun
;
Chiang, Tsung-Yu
;
Wu, Yi-Hong
This letter is the first to successfully demonstrate the 2-bit/cell wrapped-selected-gate (WSG) SONOS thin-film transistor (TFT) memory using source-side injection (SSI). Because of the higher programming efficiency of SSI, a memory window of approximately 3 V can be easily achieved in 10 mu s and 30 ms for the program and erase modes, respectively. In addition, we performed an excellent 2-bit/cell distinguish margin for 3-V memory window in WSG-SONOS TFT memory. The optimal reliability of the endurance and data retention tests can be executed by adjusting the applied voltage appropriately.
Physical Mechanism of High-Programming-Efficiency Dynamic-Threshold Source-Side Injection in Wrapped-Select-Gate SONOS for NOR-Type Flash Memory
(2009-11-01)
Wang, Kuan-Ti
;
Chao, Tien-Sheng
;
Chiang, Tsung-Yu
;
Wu, Woei-Cherng
;
Kuo, Po-Yi
For the first time, a programming mechanism for conventional source-side injection (SSI) (normal mode), substrate-bias enhanced SSI (body mode), and dynamic-threshold SSI (DTSSI) (DT mode) of a wrapped-select-gate SONOS memory is developed with 2-D Poisson equation and hot-electron simulation and programming characteristic measurement for NOR Flash memory. Compared with traditional SSI, DTSSI mechanisms are determined in terms of lateral acceleration electric field and programming current (I(PGM)) in the neutral gap region, resulting in high programming efficiency. Furthermore, the lateral electric field intersects the vertical electric field, indicating that the main charge injection point is from the end edge of the gap region close to the word gate.
Simultaneous Activation and Crystallization by Low-Temperature Microwave Annealing for Improved Quality of Amorphous Silicon Thin-Film Transistors
(2012)
Lu, Yu-Lun
;
Lee, Yao-Jen
;
Chao, Tien-Sheng
;
電子物理學系
;
Department of Electrophysics
In this study, activation and crystallization in short channel amorphous Si TFTs were demonstrated using a novel microwave annealing (MWA) technique. Both low-temperature MWA and rapid thermal annealing (RTA) were compared to study the dopant activation level. We successfully activated the source/drain region, improved the electronic mobility and suppressed the short-channel effects using low temperature MWA. This can reduce the annealing temperature and processing time below that of solid phase crystallization (SPC). This technique is promising for realizing a high utility rate of AM-LCDs with low cost. (C) 2012 The Electrochemical Society. All rights reserved.