Browsing by Author "Tsai, Jia-Ling"

Now showing 1 - 4 of 4

Back-Contacted Thin-Film GaAs Solar Cells
(2016-01-01)
Hong, Chung-Yu
;
Lin, Yu-Chen
;
Ho, Kuan-Ying
;
Tsai, Jia-Ling
;
Chien, Zhan-Tien
In this work, we present a thin-film GaAs solar cell employing via contacts for forming a back-contacted solar cell to eliminate light blocking effects and enhance photon recycling at the same time. The fabrication procedure and the characterization of the fabricated devices are discussed in this paper. From our measurement, a conversion efficiency of 6.5%, open circuit voltage of 0.95 V, and a current density of 8.6mA/cm(2) under one-sun illumination were obtained in a 5x5 mm cell.
Optimized Design of Back-Contact Thin-Film GaAs Solar Cells
(2017-01-01)
Tsai, Jia-Ling
;
Hong, Chung-Yu
;
Zhan, Tien-Chien
;
Wu, Yuh-Renn
;
Lin, Albert
In this work, we attempt to find the optimal design parameters for the doping concentration, thickness of the base region, the length and pitch of back electrodes by employing a validated Sentaurus TCAD model. Through current-voltage characteristics, one could determine best power conversion efficiency and the correlation between design parameters. While optical shadowing is eliminated in the back-contact design, it is found that electrical shading affects the cell performance and is sensitive to the electrode length and pitch. Through minimizing the length of anode, the efficiency can be elevated significantly. Moreover, a relatively wide cathode results in efficient carrier separation and superior transportation properties. Based on these simulation outcomes, we are able to optimize the design of back-contact back-junction GaAs solar cells
Photon recycling characteristics of InGaAs/GaAsP multiple quantum well solar cells incorporating a spectrally selective filter and distributed Bragg reflector
(2019-12-09)
Hong, Chung-Yu
;
Wang, Yi-Chin
;
Su, Yu-Chih
;
Tsai, Jia-Ling
;
Tung, Chao-Ming
Photon management plays a vital role in the power conversion efficiency of III-V semiconductor solar cells. However, the photon recycling characteristics of GaAs-based multi-quantum-well (MQW) solar cells employed different optical designs had yet been fully explored. In this work, we investigate the impact of the spectrally selective filter (SSF) and distributed Bragg reflector (DBR) on the photovoltaic characteristics of single-junction, strain-balanced In0.1Ga0.9As/ GaAs0.85P0.15 MQW solar cells. Specifically, the SSFs with cutoff wavelengths of 880, 910, and 940 nm are designed and implemented on MQW solar cells with and without the incorporation of a rear DBR. Photon confinement in the vertical direction is verified based on the characterizations of reflectance, electroluminescence, and external quantum efficiency. We show that the photon confinement reduces the saturation current density, up to 26 times and 3 times for the 880 nm SSF-MQW and SSF-MQW-DBR devices, respectively, compared to that of the 940 nm devices. Furthermore, by comparing the SSF-MQW-DBR solar cells under simulated one-sun and concentrated illumination conditions, the open-circuit voltage exhibits a maximal net increase for the 910 nm SSF due to tradeoff between the short-circuit and saturation current density. The proposed SSF design may offer a viable approach to boost the performance of GaAs-based MQW solar cells. (C) 2019 Optical Society of America under the terms of the OSA Open Access Publishing Agreement
Photovoltaic Characteristics of Multiple Quantum Well Solar Cells with Distributed Bragg Reflector and Selective Filters
(2016-01-01)
Hong, Chung-Yu
;
Wang, Yi-Chin
;
Hung, Mu-Min
;
Su, Yu-Chih
;
Tsai, Jia-Ling
We investigate the photon recycling characteristics of single junction solar cells incorporating 50-pairs multiple quantum wells (MQW) to exploit the high radiative recombination rate in one-dimensional carrier-confinement structures. In particular, we systematically compare solar cells with monolithically grown distributed Bragg reflectors (DBRs), as well as selective filters (SFs) with cutoff wavelengths of 880, 910, and 930 nm under standard and concentrated illumination conditions. Optical confinement in the vertical direction is verified based on the reflective spectra and electroluminescence properties. Consequently, the photo-recycling effect manifests under concentrated conditions, where the maximal open circuit voltage difference, by 12mV under 200x illumination, is achieved for MQW solar cells incorporating both the DBR and the 910-nm-cutoff SF, compared to those without the DBR or SFs. It is also revealed that the fill factor (FF) is also affected by the photon recycling effect, where incorporating SF results in the FF enhancement compared to the counterpart without the SF and the enhancement is higher for those with DBRs than without the DBRs.