學術出版;;Publications

Permanent URI for this communityhdl:11536/1

收集所有交通大學研究人員與學生個人或團體所發表之各項學術著作，涵蓋期刊論文、教師專書、學位論文等項。;;Collections of Publications of NCTU Researchers and Students Like Journal Papers and Thesis.

Browse

🏛️國立陽明交通大學機構典藏

Search Results

Now showing 1 - 7 of 7

Diamond nucleation on Cu by using MPCVD with a biasing pretreatment
(2001-11-01)
Chuang, KL
;
Chang, L
;
Lu, CA
;
材料科學與工程學系
;
Department of Materials Science and Engineering
Bias enhanced nucleation of diamond on polycrystalline Cu substrates has been investigated. With CH4 concentration increased, the nucleation density is increased and saturated at 10% CH4, but the quality of diamond is decreased. Bias voltages also play an important role on the nucleation of diamond. It is found that the nucleation density is highest when the voltage was set at -250 V. (C) 2001 Elsevier Science B.V. All rights reserved.
Diamond growth onCoSi(2)/Si by bias-enhanced microwave plasma chemical vapor deposition method
(2001-11-01)
Chen, MR
;
Chang, L
;
Chang, DF
;
Chen, HG
;
材料科學與工程學系
Diamond was grown on polycrystalline CoSi2/Si substrates by bias-enhanced microwave plasma chemical vapor deposition. Both of the positive and negative biasing effects were investigated by microstructural characterization. It has been found that nucleation density can reach similar to 10(9) cm(-2) with positive biasing, much higher than with negative biasing. Cross-sectional transmission electron microscopy shows that diamond deposited by positive biasing grows on a relatively smooth CoSi2 surface, while the etching effect of ion bombardment during negative biasing results in a rough CoSi2 surface. The diamond morphology obtained with negative bias has a flat surface with a strong (1 0 0) texture. (C) 2001 Elsevier Science B.V. All rights reserved.
Highly oriented diamond growth on SixGe1-x (100) thin films
(2004-11-01)
Chang, TF
;
Chang, L
;
材料科學與工程學系
;
Department of Materials Science and Engineering
Highly oriented (100) diamond films have been successfully grown on SixGe1-x(100) thin films by bias enhanced nucleation (BEN) in microwave plasma chemical vapor deposition (MPCVD) system. Raman spectra show the 1332 cm(-1) peak which proves the formation of diamond. Diamond nucleation density on SixGe1-x substrate estimated by scanning electron microscopy is higher than 10(9) cm(-2). The interface between diamond and SixGe1-x substrate was characterized by transmission electron microscopy (TEM). About 20 nm decrease in thickness of the SixGe1-x film. was observed after bias enhanced nucleation step. TEM shows the existence of silicon carbide and heteroepitaxial diamond grains grown on SixGe1-x substrate. Characterization from high-resolution TEM on the specimen of short time deposition reveals that a number of epitaxial diamond grains were directly nucleated on SixGe1-x with {111} interplanar spacing ratio of diamond and SixGe1-x of 2:3. The diamond nucleation is found to be preferred on the ridge position of the rough substrate surface. Diamond {100} facets were quickly developed in the early stage of growth. (C) 2004 Elsevier B.V. All rights reserved.
Diamond nucleation on Ni3Al substrate using bias enhanced nucleation method
(2005-02-01)
Chen, HG
;
Chang, L
;
材料科學與工程學系
;
Department of Materials Science and Engineering
Diamond deposition with positive and negative bias enhanced nucleation (BEN) pretreatments on mirror-polished polycrystalline Ni3Al substrates has been investigated, respectively. It was found that diamond deposition on the substrates under both biasing exhibited significant variations among grains of different orientations. The substrate surface was found to be rough in the case of negative biasing, whereas it was smooth in the case of positive biasing. Thus, the correlation of the crystallographic orientation of grains on the samples with the diamond nucleation behavior was systematically characterized for the case of positive biasing by electron backscattered diffraction method with scanning electron microscopy. Diamond deposition on Ni3Al grains near (111) orientation results in higher nucleation densities, while the densities are low on (110) and (100) oriented grains. Also, the interfacial microstructure between diamond deposited and Ni3Al was characterized by cross-sectional transmission electron microscopy. (C) 2004 Elsevier B.V. All rights reserved.
The orientation effect of silicon grains on diamond deposition
(2005-11-01)
Su, YH
;
Chang, L
;
Chen, HG
;
Yan, JK
;
Chou, T
Diamond deposition on mirror-polished polycrystalline silicon substrates which have grains in various orientations has been investigated using electron backscatter diffraction (EBSD) method with scanning electron microscopy (SEMI). Diamond was deposited by microwave plasma chemical vapor deposition with application of a negative bias voltage oil the substrate. The evidence from systematic SEM observations shows that silicon orientation determined by EBSD has a strong effect on diamond nucleation. In general, the diamond nucleation density on Si grains oriented close to < 100 > is the highest, while it is the lowest for those grains close to < 111 >, under the same experimental conditions for deposition. The same phenomena have been observed in the range of methane concentration from 2% to 4% in hydrogen. (c) 2005 Elsevier B.V. All rights reserved.
Microwave plasma chemical vapor deposition of cone-like structure of diamond/SiC/Si on Si (100)
(2005-11-01)
Yan, JK
;
Chang, L
;
材料科學與工程學系
;
Department of Materials Science and Engineering
Diamond deposition on I x I cm 2 Si (100) substrates with bias was carried out by microwave plasma chemical vapor deposition (MPCVD). Distribution of deposited diamonds has been significantly improved in uniformity over all the Si substrate surface area by using a novel designed dome-shaped Mo anode. The deposits were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), and Raman analysis. SEM observations show that there is a high density of cone-like particles uniformly deposited on the surface of the substrate in short bias nucleation period. The average diameter, height and density of cone-like structure were increased with methane concentration in the bias stage. TEM reveals that the cone-like structure is actually composed of Si conic crystal covered with diamond. Between Si and diamond, a thin layer of cubic SiC is found in epitaxy with Si. Furthermore, for 3% CH4 concentration, the range of diameter of cone-like structure was about 2090 nm and the size of diamond was about 10-60 nm. (c) 2005 Elsevier B.V. All rights reserved.
Chemical vapor deposition of uniform and high-quality diamond films by bias-enhanced nucleation method
(2006-03-01)
Yan, JK
;
Chang, L
;
材料科學與工程學系
;
Department of Materials Science and Engineering
Diamond films on 1 x 1 cm(2) Si (100) substrates were synthesized by microwave plasma chemical vapor deposition (MWCVD) using mixture of methane and hydrogen gases. Bias-enhanced nucleation method was used to avoid any mechanical pretreatments. Distribution of deposited diamond crystallites in terms of density, size, and morphology has been significantly improved over all the Si substrate surface area by using a novel designed Mo anode. Films were characterized from the center to the edges of substrates using scanning electron microscopy, transmission electron microscope, and Raman analysis. The results also show that uniform diamond films can be obtained by short bias nucleation period using a dome-shaped Mo anode. The diamond crystallites were directly deposited on Si substrate. Using 2% CH4 in the growth stage, high quality diamond films in the < 100 > texture can be obtained with relatively smooth surface. (c) 2005 Elsevier B.V. All rights reserved.

學術出版;;Publications

Browse

Filters

Settings

Sort By

Results per page

🏛️國立陽明交通大學機構典藏

Search Results