完整後設資料紀錄
DC 欄位語言
dc.contributor.authorHuang, Yi-Hsuanen_US
dc.contributor.authorChen, Chiao-Hsinen_US
dc.contributor.authorLiu, Yao-Hsienen_US
dc.date.accessioned2017-04-21T06:49:19Z-
dc.date.available2017-04-21T06:49:19Z-
dc.date.issued2016en_US
dc.identifier.isbn978-0-7918-5033-6en_US
dc.identifier.urihttp://hdl.handle.net/11536/134588-
dc.description.abstractHeat transfer of mist flow in a rib-roughened square duct was experimentally determined using infrared thermography. The mist flow was generated by introducing fine dispersed water droplets into the air stream. A constant heat flux was applied to the surface during the test and the surface temperature was kept below the boiling point. The heat transfer measurement was performed on a heated surface located inside a vertical square duct with a hydraulic diameter of 4cm. The air/water mist flow was carried upward by air flow from a blower placed at the bottom of the duct. The flow passed through a flow straightener and entered the heated region of the square duct. The Reynolds numbers of the carrier fluid were 7900, 16000 and 24000. The results showed that mist flow cooling achieved higher heat transfer rates compared to the air cooling. Thin liquid films formed on the heated surface by the mist flow and the evaporation from the droplets and liquid film contributed to a higher heat removal rate. The heat transfer enhancement on the smooth surface by the mist flow was 4 to 6 times higher compared to the air flow. Rib turbulators were typically applied in channel walls for heat transfer enhancement in gas turbine blades or heat exchangers. Ribs caused flow reattachment and promoted flow mixing. The higher Nusselt number induced by flow reattachment can be visualized using infrared thermography. For the ribbed case, the heat transfer contours were reported based the regions between ribs. Square brass ribs were used and the rib height-to-hydraulic diameter ratio was 0.05. The rib pitch-to-height ratios were 10 and 20 in the current study. For the mist flow in the ribbed duct, the intense flow mixing and secondary flow caused by the ribs blew away liquid films on the surface. The heat transfer enhancement near the reattachment region was mainly influenced by the droplet impingement on the surface. In the ribbed duct, the heat transfer enhancement from using the mist flow was 2.5 to 3.5 times higher compared to the air flow.en_US
dc.language.isoen_USen_US
dc.titleNON-BOILING HEAT TRANSFER OF AIR/WATER MIST FLOW IN A SQUARE DUCT WITH ORTHOGONAL RIBSen_US
dc.typeProceedings Paperen_US
dc.identifier.journalPROCEEDINGS OF THE ASME SUMMER HEAT TRANSFER CONFERENCE, 2016, VOL 2en_US
dc.contributor.department機械工程學系zh_TW
dc.contributor.departmentDepartment of Mechanical Engineeringen_US
dc.identifier.wosnumberWOS:000392359400010en_US
dc.citation.woscount0en_US
顯示於類別:會議論文