Full metadata record
DC FieldValueLanguage
dc.contributor.authorLi, J. S.en_US
dc.contributor.authorLi, Q.en_US
dc.contributor.authorCai, W. H.en_US
dc.contributor.authorLi, F. C.en_US
dc.contributor.authorChen, C. Y.en_US
dc.date.accessioned2018-08-21T05:53:36Z-
dc.date.available2018-08-21T05:53:36Z-
dc.date.issued2018-04-01en_US
dc.identifier.issn1727-7191en_US
dc.identifier.urihttp://dx.doi.org/10.1017/jmech.2017.32en_US
dc.identifier.urihttp://hdl.handle.net/11536/144903-
dc.description.abstractWe numerically verify better fluid mixing efficiency can be achieved by alternating injection scheme in a heterogeneous porous medium, whose permeability heterogeneity is characterized by two statistical parameters, i.e., the variance s and the correlation length 1. Nevertheless, the fingering pattern is strongly affected by permeability distribution to result in similar fingering interface on each of injected layer of less viscous fluids. Instead of randomly chaotic fingering interaction in a homogeneous condition, more orderly channeling interaction occurs in a heterogeneous medium. As a result, higher Peclet number Pe (relative measure of advection and diffusion effects) generally leads to worse mixing efficiency in a heterogeneous medium, which might contradict the result found in a homogeneous case. By the same token, in the cases which strong chaotic fingering interaction already exists in homogeneous conditions, e.g., sufficiently short alternating injection interval Delta t, large viscosity contrast A and high Pe, the presence of permeability heterogeneity would constrain the randomly chaotic fingering interaction and favors the more orderly channeling interaction, so that mixing efficiency is deteriorated compared with the corresponding homogeneous case.en_US
dc.language.isoen_USen_US
dc.subjectHeterogeneous porous mediaen_US
dc.subjectViscous fingeringen_US
dc.subjectAlternating injectionen_US
dc.subjectMixing efficiencyen_US
dc.titleMIXING EFFICIENCY VIA ALTERNATING INJECTION IN A HETEROGENEOUS POROUS MEDIUMen_US
dc.typeArticleen_US
dc.identifier.doi10.1017/jmech.2017.32en_US
dc.identifier.journalJOURNAL OF MECHANICSen_US
dc.citation.volume34en_US
dc.citation.spage167en_US
dc.citation.epage176en_US
dc.contributor.department機械工程學系zh_TW
dc.contributor.departmentDepartment of Mechanical Engineeringen_US
dc.identifier.wosnumberWOS:000430732600009en_US
Appears in Collections:Articles