A Flip-Chip-Assembled W-Band Receiver in 90-nm CMOS and IPD Technologies

檔案

本條目沒有附加檔案。

至出版者網站查看(DOI) ›

日期

2019-04-01

類型

期刊名稱

IEEE TRANSACTIONS ON MICROWAVE THEORY AND TECHNIQUES

卷期與頁次

第 67 卷第 4 期,頁 1628–1639

ISSN

0018-9480

語言

英文

摘要

A flip-chip-assembled W-band receiver composed of a 90-nm CMOS chip and an integrated-passive-device (IPD) carrier is presented in this paper. The chip which integrates a low-noise amplifier, a single-sideband mixer, a frequency doubler (FD), and a wide-band variable-gain amplifier, is flip-chip packaged to the IPD carrier through a low-loss interconnect. The simulated loss of the interconnect without any compensation network is only 0.95 dB at 94 GHz. The FD can provide differential output without any additional lossy balun required, effectively increasing the FD output power, and hence relaxing the local oscillator generation circuit design. The experimental results show that the proposed packaged receiver can provide a variable gain from 11.3 to 48.2 dB, while having an input 1-dB compression point from -43.7 to -29 dBm as the RF frequency is 90 GHz. The intermediate bandwidth and minimum noise figure can be 1.0 GHz and 7.8 dB, respectively. The proposed receiver only consumes 73.9 mW from a 1.2-V supply. As compared with prior works, the proposed receiver exhibits higher gain, lower noise, and lower power dissipation even though a less-advanced 90-nm CMOS technology is adopted. To the best of the authors' knowledge, this is the first W-band CMOS receiver assembled on an IPD carrier reported thus far.

所屬典藏

期刊論文
顯示完整詮釋資料 統計資料

引用此條目

Li, C.-H., Hsieh, W.-T., & Chiu, T.-Y. (2019). A Flip-Chip-Assembled W-Band Receiver in 90-nm CMOS and IPD Technologies. IEEE TRANSACTIONS ON MICROWAVE THEORY AND TECHNIQUES, 67(4), 1628–1639. https://doi.org/10.1109/TMTT.2019.2894426

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/151972