A 5-GHz direct-conversion receiver with I/Q phase and gain error calibration

Abstract

This paper describes the design of a 5GHz direct conversion receiver with phase and gain errors calibration for WLAN application. Integrated both LNA and mixer in a single chip, the conversion gain of the RF receiver is switch-able to compromise between linearity and noise performance. In addition, calibration schemes are proposed to compensate gain and phase errors in the I/Q signal paths. By means of this technique, the measured phase error is reduced to be less than 0.6 degrees and gain error less than 0.2 dB. The receiver provides a conversion gain of 28.2 dB in the high gain mode and 11.6 dB in the low gain mode within the signal bandwidth. The overall noise figure is 6.4dB in the high gain mode, and the third-order input intercept point (IIP3) is about -6.8dBm in the low gain mode. Implemented in a 0.18-mu m CMOS technology, it consumes 37.4 mW from a 1.8 V supply. Chip area is 1.64 mm(2).