Improvement of machining accuracy by fuzzy logic at corner parts for wire-EDM
檔案
- 000170019000009.pdf (226.4 KB, Adobe PDF)
日期
2001-09-16
類型
系所
期刊名稱
FUZZY SETS AND SYSTEMS
卷期與頁次
第 122 卷第 3 期,頁 499–511
ISSN
0165-0114
語言
英文
摘要
Wire electrical discharge machining (wire-EDM) has always occupied an important position in some production fields, due to its capability of machining hard materials and intricate shapes. However, the machining accuracy, especially at corner parts, may be destroyed because of some phenomena such as wire deflection and vibration, etc. The purpose of this paper is to develop a control strategy based on fuzzy logic so that the machining accuracy at corner parts for wire-EDM can be improved. The fuzzy rules based on the wire-EDM's physical characteristics, experimental data, and operator's experience are constructed, so that the reduced percentage of sparking force can be determined by a multi-variables fuzzy logic controller. The objective of the total control is to improve the machining accuracy at corner parts, but still keep the cutting feedrate at fair values. As a result of experiments, machining errors of corner parts, especially in rough-cutting, can be reduced to less than 50% of those in normal machining, while the machining process time increases not more than 10% of the normal value. (C) 2001 Elsevier Science B.V. All rights reserved.
關鍵詞
fuzzy controlfuzzy rulesmembership functionelectrical discharge machiningwire electrodesparking force所屬典藏
期刊論文引用此條目
Lin, C., Chung, I., & Huang, S. (2001). Improvement of machining accuracy by fuzzy logic at corner parts for wire-EDM. FUZZY SETS AND SYSTEMS, 122(3), 499–511. https://doi.org/10.1016/S0165-0114(00)00034-8
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/29391