標題: MEASUREMENT OF RESIDUAL-STRESSES IN WELDED STEEL JOINTS USING HOLE DRILLING METHOD
作者: WENG, CC
LO, SC
交大名義發表
土木工程學系
National Chiao Tung University
Department of Civil Engineering
公開日期: 1-三月-1992
摘要: An experimental investigation of the residual stresses in three types of welded structural steel joint is presented. A total of twelve specimens was tested. In this investigation, the blind hole-drilling method of ASTM E837 was used - adapted and improved for determination of residual stresses. To account for the effect of local plasticity due to stress concentration near the drilled hole, new calibration coefficients were obtained by carrying out a series of calibration tests. Then, the residual stresses in the welded joints were determined using the new coefficients. The improved hole drilling method presented in this paper was found to be much less time consuming than the conventional sectioning (saw cutting) method for residual stress measurement. The final results obtained in this study showed good agreement with the residual stresses obtained by previous researchers using the sectioning method.
URI: http://hdl.handle.net/11536/3494
ISSN: 0267-0836
期刊: MATERIALS SCIENCE AND TECHNOLOGY
Volume: 8
Issue: 3
起始頁: 213
結束頁: 218
顯示於類別:期刊論文