完整後設資料紀錄
DC 欄位語言
dc.contributor.authorWANG, WKen_US
dc.contributor.authorKUO, CTen_US
dc.contributor.authorCHIN, TSen_US
dc.date.accessioned2014-12-08T15:05:23Z-
dc.date.available2014-12-08T15:05:23Z-
dc.date.issued1991en_US
dc.identifier.issn0265-0916en_US
dc.identifier.urihttp://hdl.handle.net/11536/3923-
dc.description.abstractAir pockets have long been an unsatisfactory feature of the planar flow casting (PFC) process, which is a potential method for manufacturing thin strip. In this study, heating the gas on the wheel surface upstream of the puddle by means of an arc plasma was used to improve the puddle stability and inhibit air pocket formation. It was found that in the plasma heating region air pockets were almost invisible microscopically and the polishing tracks on the wheel surface were well-duplicated on the wheel side contact surface of the cast ribbon, while in the unheated regions a conventional air pocket characteristic was observed. This fact confirms that the thermal expansion of the gas in the converging contact angle, which builds up a local high pressure region at the melt/substrate interface, lifts up the melt and enhances the gas entrapment. Arc plasma heating reduces the temperature difference, hence the pressure build-up. The increase in temperature and pressure of the gas at the melt/substrate interface was calculated to confirm its role in air pocket formation. The plasma heating can improve wheel side contact thereby increasing the cooling rate of the ribbon during casting.en_US
dc.language.isoen_USen_US
dc.titleEFFECT OF ARC PLASMA-HEATING ON THE AIR POCKET FORMATION DURING THE PLANAR FLOW CASTINGen_US
dc.typeArticleen_US
dc.identifier.journalINTERNATIONAL JOURNAL OF RAPID SOLIDIFICATIONen_US
dc.citation.volume6en_US
dc.citation.issue3-4en_US
dc.citation.spage285en_US
dc.citation.epage295en_US
dc.contributor.department機械工程學系zh_TW
dc.contributor.departmentDepartment of Mechanical Engineeringen_US
dc.identifier.wosnumberWOS:A1991HA95800006-
dc.citation.woscount0-
顯示於類別:期刊論文