學術出版;;Publications

Permanent URI for this communityhdl:11536/1

收集所有交通大學研究人員與學生個人或團體所發表之各項學術著作，涵蓋期刊論文、教師專書、學位論文等項。;;Collections of Publications of NCTU Researchers and Students Like Journal Papers and Thesis.

Browse

🏛️國立陽明交通大學機構典藏

Search Results

Now showing 1 - 10 of 10

A high 2LO-to-RF isolation GaInP/GaAs HBT sub-harmonic Gilbert mixer using three-level topology
(2006)
Wu, Tzung-Han
;
Meng, Chinchun
;
Huang, Guo-Wei
;
電信工程研究所
;
Institute of Communications Engineering
A 5.2 GHz three-level sub-harmonic downconversion Gilbert mixer using GaInP/GaAs HBT (Heterojunction Bipolar Transistor) technology is demonstrated in this paper. The LO frequency is half of the RF frequency for the three-level sub-harmonic mixer architecture; therefore, the RF frequency is 5.2004 GHz and LO frequency is 2.6 GHz. The conversion gain is 14.5 dB, IP(1dB') is -18 dBm, IIP(2) is 13 dBm and the IIP(3) is -5 dBm when the LO power equals to -8 dBm. The 2LO-to-RF leakage is about -83 dBm. The RF input return loss is better than -18 dB from DC to 6GHz.
Kukielka and Meyer Wideband Dual Feedback Amplifiers Using GaInP/GaAs HBT Technology
(2009)
Syu, Jin-Siang
;
Wu, Tzung-Han
;
Meng, Chinchun
;
Huang, Guo-Wei
;
電信工程研究所
GaInP/GaAs HBT inductorless wideband amplifiers using shunt-series shunt-shunt dual-feedback topology (Kukielka topology) and shunt-series series-shunt dual-feedback topology (Meyer topology) are demonstrated in this paper. Three amounts of feedback are applied on each topology. At the high gain mode, the Kukielka/Meyer wideband amplifier achieves the small-signal power gain of 30/27 dB with the 3-dB bandwidth of 6 GHz at a 5-V supply. The noise figure of both amplifiers is lower than 3 dB within 6 GHz. Increasing the amount of feedback widens the bandwidth at the cost of power gain and noise figure degradation.
Broadband GaInP/GaAs HBT regenerative frequency divider with active loads
(2007)
Wei, Hung-Ju
;
Meng, Chinchun
;
Chang, YuWen
;
Huang, Guo-Wei
;
電信工程研究所
An integrated GaInP/GaAs heterojunction bipolar transistor (HBT) regenerative frequency divider (RFD) with active loads is demonstrated at 4 GHz-26 GHz. In this work, the RFDs with resistive loads and active loads are fabricated in the same chip for comparison. From the measured results, the active-loading type obviously has wider operating frequency and lower input sensitivity. The f(max)/f(min) ratio of 6.5 is higher than that of general RFDs. The core power consumption is 36.7mW at the supply voltage of 5 V. The chip size is 1.0 x 1.0 mm(2).
Inductorless broadband RF front-end using 2 um GaInP/GaAs HBT technology
(2007)
Wu, Tzung-Han
;
Meng, Chinchun
;
Huang, Guo-Wei
;
電信工程研究所
;
Institute of Communications Engineering
A GaInP/GaAs HBT broadband RF front-end consisting of a low noise wideband amplifier and a micromixer is demonstrated in this paper. The major advantage of this work is the elimination of inductors and thus the chip area can be greatly saved. The bandwidth of the RF front-end is up to 7 GHz. The measured conversion gain is higher than 25 dB from 1 GHz to 7 GHz and the noise figure of the RF front-end is less than 8 dB within the bandwidth.
GaInP/GaAs HBT sub-harmonic Gilbert mixers using stacked-LO and leveled-LO topologies
(2007-05-01)
Wu, Tzung-Han
;
Tseng, Sheng-Che
;
Meng, Chin-Chun
;
Huang, Guo-Wei
;
電信工程研究所
This paper discusses and demonstrates the most popular sub-harmonic Gilbert mixers in 2-mu m GaInP/GaAs HBT technology. High two local oscillators (2LO)-to-RF isolation is important to alleviate the self-mixing problem of the sub-harmonic mixer. The demonstrated GaInP/GaAs HBT stacked-local oscillator (LO) mixer topology has achieved the best 2LO-to-RF isolation when compared with the previous literature. On the other hand, the leveled-LO sub-harmonic mixers have advantages in terms of the high speed and low dc supply voltage at the cost of much larger LO pumping power. Among all the structures, the bottom-LO sub-harmonic mixer has the lowest current consumption and the simplest circuit structure at the expense of the 2LO-to-RF isolation.
A High-Speed HBT Prescaler Based on the Divide-by-Two Topology
(2007)
Wei, Hung-Ju
;
Meng, Chinchun
;
Chang, Yuwen
;
Lin, Yi-Chen
;
Huang, Guo-Wei
This paper demonstrates the Divide-by4/5 prescalers with merged AND gates in 2 mu m GaInP/GaAs heterojunction bipolar transistor (HBT) and 035 mu m SiGe HBT technologies. By biasing the HBT near the peak transit-time frequency (f(tau)), the maximum operating frequency of a D-type flip-flop (D-FF) can be promoted. At the supply voltage of 5 V, the GaInP/GaAs prescaler operates from 30 MHz to 5.2 GHz, and the SiGe prescaler has the higher-speed performance of 1 GHz similar to 8 GHz at the cost of power consumption.
GaInP/GaAs HB broadband inductorless receiver
(2008-01-01)
Wu, Tzung-Han
;
Meng, Chinchun
;
Huang, Guo-Wei
;
電信工程研究所
;
Institute of Communications Engineering
A GaInP/GaAs HBT broadband RF front-end consisting of a low-noise wideband amplifier and a micromixer is demonstrated in this article. The major advantage of this work is the elimination of inductors and thus the chip area can be greatly saved. The bandwidth of the RF front-end is up to 7 GHz. The measured conversion gain is higher than 25 dB from 1 to 7 GHz and the noise figure of the RF front-end is less than 8 dB within the bandwidth. (c) 2007 Wiley Periodicals, Inc.
Comparison of GaInP/GaAs HBT RFDs with resistive loads and shunt-shunt feedback active loads
(2008-02-01)
Wei, Hung-Ju
;
Meng, Chinchun
;
Chang, Yuwen
;
Huang, Guo-Wei
;
電信工程研究所
An integrated GaInP/GaAs heterojunction bipolar transistor (HBT) regenerative frequency divider (RFD) with active loads is demonstrated from 4 to 26 GHz. In this work, the RFDs with resistive loads and active loads are fabricated in the same chip for comparison. From the measured results, the active loading type obviously has wider operating frequency and lower input sensitivity. The f(max)/f(min), ratio of 6.5 is higher than that of general RFDs. The core power consumption is 36.7 mW at the supply voltage of 5 V The chip size is 1.0 x 1.0 mm(2). (c) 2007 Wiley Periodicals, Inc.
Compact GaInP/GaAs HBT Gilbert Mixers With On-Chip Active LO Balun
(2007)
Wu, Tzung-Han
;
Lin, Yi-Chen
;
Meng, Chinchun
;
Wu, Tse-Hung
;
Wei, Hung-Ju
A Gilbert micromixer is demonstrated in this paper using GaInP/GaAs HBT technology. The RF, LO, and IF ports of the micromixer are all single-ended using the on-chip active LO balun. The port-to-port isolation has its best performance when the LO signal is balanced. The stand-along micromixer is suitable for hybrid RF system applications. The fully matched high linearity micromixer has the conversion gain of 12 dB, IP(1dB) of -9 dBm, IIP(3) of 1 dBm when input IF=300 MHz, LO=3.5 GHz and output RF=3.8 GHz.
LOW-NOISE GaInP/GaAs HBT WIDEBAND DUAL FEEDBACK AMPLIFIERS USING KUKIELKA AND MEYER TOPOLOGIES
(2010-07-01)
Syu, Jin-Siang
;
Wu, Tzung-Han
;
Meng, Chinchun
;
Huang, Guo-Wei
;
電子工程學系及電子研究所
GaInP/GaAs HBT inductorless wideband amplifiers using shunt-series shunt-shunt dual-feedback topology (Kukielka topology) and shunt-series series-shunt dual-feedback topology (Meyer topology) are demonstrated in this article. Three amounts of feedback are applied on each topology. At the high-gain mode, the Kukielka/Meyer wideband amplifier achieves the small-signal power gain of 30127 dB with the 3-dB bandwidth of 6 GHz at a 5 V supply. The noise figure of both amplifiers is lower than 3 dB within 6 GHz. To increase the amount of feedback widens the bandwidth at the cost of power gain and noise figure degradation. (C) 2010 Wiley Periodicals, Inc. Microwave Opt Technol Lett 52: 1486-1489, 2010; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/mop.25280

學術出版;;Publications

Browse

Filters

Settings

Sort By

Results per page

🏛️國立陽明交通大學機構典藏

Search Results