Simulation and experimentation of a microfluidic device based on electrowetting on dielectric

檔案

日期

2007-12-01

類型

期刊名稱

BIOMEDICAL MICRODEVICES

卷期與頁次

第 9 卷第 6 期,頁 777–786

ISSN

1387-2176

語言

英文

摘要

Electrowetting on dielectric (EWOD) moving fluid by surface tension effects offers some advantages, including simplicity of fabrication, control of minute volumes, rapid mixing, low cost and others. This work presents a numerical model using a commercial software, CFD-ACE+, and an EWOD system including a microfluidic device, a microprocessor, electric circuits, a LCD module, a keypad, a power supply and a power amplifier. The EWOD model based on a reduced form of the mass conservation and momentum equations is adopted to simulate the fluid dynamics of the droplets. The EWOD device consists of the 2 x 2 mm bottom electrodes (Au/Cr), a dielectric layer of 3,000 angstrom nitride, 500 angstrom Teflon and a piece of indium tin oxide (ITO)-coated glass as the top electrode. The complete EWOD phenomenon is elucidated by comparing simulation with the experimental data on droplet transportation, cutting and creation. In transportation testing, the speed of the droplet is 6 mm/s at 40 V-dc. In addition, the droplet division process takes 0.12 s at 60 V-dc in the current case. Finally, a 347 nl droplet is successfully created from an on-chip reservoir at 60 V-dc.

所屬典藏

期刊論文
顯示完整詮釋資料 統計資料

引用此條目

Jang, L.-S., Lin, G.-H., Lin, Y.-L., Hsu, C.-Y., Kan, W.-H., & Chen, C.-H. (2007). Simulation and experimentation of a microfluidic device based on electrowetting on dielectric. BIOMEDICAL MICRODEVICES, 9(6), 777–786. https://doi.org/10.1007/s10544-007-9089-8

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/10019