標題: Adjusting optical resonance thickness to increase the conversion efficiency of polymer solar cells
作者: Tsai, Yu Sheng
Lin, Jian-Shian
Chu, Wei-Ping
Wang, Po-Hsun
Juang, Fuh-Shyang
Chung, Ming-Hua
Chen, Chin-Ming
Liu, Mark O.
材料科學與工程學系
Department of Materials Science and Engineering
關鍵字: P3HT;PCBM;Polymer;Solar cells;Optical resonance
公開日期: 1-五月-2010
摘要: The derivatives of C(60), [6,6]-phenyl C61-butyric acid methyl ester (PCBM), and 3-hexylthiophene (P3HT) were dissolved in DCB solvent, then spin coated into an active layer for polymer solar cells. The experimental parameters were studied carefully to obtain the optimum power conversion efficiency (PCE). The primary process for generation of photocurrent in an organic photovoltaic device is the generation of bound electron-hole pairs (excitons) by absorption of energy (photons) from the optical electric field. Modeling was based on the assumption that the photocurrent generation process is the result of the creation and diffusion of photogenerated species (excitons), which are dissociated by charge transfer at the active layer. Improve organic optics absorb by insert organic layer (CuPc or C60) at the active layer/Al interface. This research is divided into two components. First part, we use n-type C60 as transmission layer. When an optimum thickness of C(60) is 5 nm, the J(sc) of polymer solar cell can be increased from 7.26 mA/cm(2) to 7.7 mA/cm(2). The V(oc) decrease is because the energy level of C60 LUMO (lowest unoccupied molecular orbital) at 4.5 eV is higher than the 3.7 eV of PCBM. Second part, we use p-type CuPc as transmission layer. When an optimum thickness of CuPc is 3 nm, the short circuit photo-current density (J(sc)) and open circuit voltage (Voc) of polymer solar cell can be increased from 7.26 mA/cm2 to 8.0 mA/cm2 and 0.56-0.58 V, respectively. The reason is the same as C(60). The Voc increase is because the energy level of CuPc LUMO (lowest unoccupied molecular orbital) at 3.1 eV is lower than the 3.7 eV of PCBM. The Jsc increase is because the 3 nm of CuPc leads to a constructive interference happened in the active layer and thus optical absorption increases. In this study we used 3 nm of CuPc at the active layer/Al interface to enhance the short circuit current density, and the efficiency was increased to 2.94%. (C) 2010 Elsevier B. V. All rights reserved.
URI: http://dx.doi.org/10.1016/j.cap.2010.02.015
http://hdl.handle.net/11536/11345
ISSN: 1567-1739
DOI: 10.1016/j.cap.2010.02.015
期刊: CURRENT APPLIED PHYSICS
Volume: 10
Issue: 3
起始頁: S502
結束頁: S505
顯示於類別:會議論文


文件中的檔案:

  1. 000280600000039.pdf

若為 zip 檔案,請下載檔案解壓縮後,用瀏覽器開啟資料夾中的 index.html 瀏覽全文。