標題: Electrical discharge abrasive drilling of hard materials using a metal matrix composite electrode
作者: Shu, Kuen Ming
Shih, Hung Rung
Tu, G. C.
材料科學與工程學系
Department of Materials Science and Engineering
關鍵字: Cu/SiCp composite;electrical discharge abrasive drilling;material removal rate;surface roughness
公開日期: 1-七月-2006
摘要: The main object of the present work was to develop an electrical discharge abrasive drilling (EDAD) methodology to remove the re-solidified layer through the grinding induced by a metal matrix composite electrode prior to the re-solidification of molten material. A metal matrix composite (Cu/SiCp) electrode, with an electroless pretreatment of Cu coating on SiCp to enhance bonding status between Cu and SiCp, was made with a rotating device and this was employed to study the EDAD technology. The machinability of the mold steel HPM50 and tungsten carbide P20 was investigated by the combined technologies of EDAD. The machined surfaces of these materials were examined by scanning electron microscopy (SEM) and their surface roughness measured by a profilemeter. From the experimental results, it was found that the EDAD machining efficiency was three to seven times than that of normal EDM operation for mold steel. However, the efficiency improvement is hardly detectable for tungsten carbide. In addition, the surface roughness of both materials could be improved in comparison with that achieved after EDM.
URI: http://dx.doi.org/10.1007/s00170-005-2571-7
http://hdl.handle.net/11536/12110
ISSN: 0268-3768
DOI: 10.1007/s00170-005-2571-7
期刊: INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY
Volume: 29
Issue: 7-8
起始頁: 678
結束頁: 687
顯示於類別:期刊論文


文件中的檔案:

  1. 000238835600007.pdf

若為 zip 檔案,請下載檔案解壓縮後,用瀏覽器開啟資料夾中的 index.html 瀏覽全文。