標題: Relieving the current crowding effect in flip-chip solder joints during current stressing
作者: Liang, SW
Shao, TL
Chen, C
Yeh, ECC
Tu, KN
材料科學與工程學系
Department of Materials Science and Engineering
公開日期: 1-一月-2006
摘要: Three-dimensional simulations for relieving the current crowding effect in solder joints under current stressing were carried out using the finite element method. Three possible approaches were examined in this study, including varying the size of the passivation opening, increasing the thickness of Cu underbump metallization (UBM), and adopting or inserting a thin highly resistive UBM layer. It was found that the current crowding effect in the solder bump could be successfully relieved with the thick Cu UBM or with the highly resistive UBM. Compared to the solder joint with Al/Ni(V)/Cu UBM, for instance, the maximum current density in a solder bump decreased dramatically by a factor of fifteen, say from 1.11 x 10(5) A/cm(2) to 7.54 x 10(3) A/cm(2) when a 20-pm-thick Cu UBM was used. It could be lowered by a factor of seven, say to 1.55 x 10(4) A/cm(2), when a 0.7-mu m UBM of 14770 mu Omega cm was adopted. It is worth noting that although a resistive UBM layer was used, the penalty on overall resistance increase was negligible because the total resistance was dominated by the Al trace instead of the solder bump. Thermal simulation showed that the average temperature increase due to Joule heating effect was only 2.8 degrees C when the solder joints with UBM of 14770 mu Omega cm were applied by 0.2 A.
URI: http://dx.doi.org/10.1557/jmr.2006.0004
http://hdl.handle.net/11536/12838
ISSN: 0884-2914
DOI: 10.1557/jmr.2006.0004
期刊: JOURNAL OF MATERIALS RESEARCH
Volume: 21
Issue: 1
起始頁: 137
結束頁: 146
顯示於類別:期刊論文


文件中的檔案:

  1. 000234582900019.pdf

若為 zip 檔案,請下載檔案解壓縮後,用瀏覽器開啟資料夾中的 index.html 瀏覽全文。