Synthesis and characterization of Ni-P-CNT's nanocomposite film for MEMS applications

檔案

日期

2005-09-01

類型

期刊名稱

IEEE TRANSACTIONS ON NANOTECHNOLOGY

卷期與頁次

第 4 卷第 5 期,頁 539–547

ISSN

1536-125X

語言

英文

摘要

An electroless phosphorus nickel-carbon nanotube's (Ni-P-CNT) nanocomposite film synthesis and related process for microelectromechanical systems device fabrication have been successfully developed and presented in this paper. With a special acid oxidative method, a well-dispersed nickel-CNT's colloidal solution has been produced without any aggregation, which is very suitable for microstructure fabrication. The nanoindentation measurement indicates that the Young's modulus and hardness of the Ni-P-CNT's nanocomposite film plated in the bath with 0.028-g/L CNTs can greatly increase up to 665.9 and 28.9 GPa, respectively, which are approximately four times larger than that of pure nickel. Moreover, the content of CNTs in the Ni-P-CNT's films is measured by an elemental analyzer. Via the electrical resistivity measurement using a four-point probe, it is found that the electrical property of the nanocomposite film can be well characterized using a Maxwell-Wagner model for a two-phase mixture. The performance improvements of the electrothermal microactuator made of the nanocomposite, including device strength and power efficiency, have been proven similar to the actuator made of the Ni-diamond composites by electrolytic plating by Tsai et al, but with more efficiency and higher strength than the Ni-diamond device does.

所屬典藏

期刊論文
顯示完整詮釋資料 統計資料

引用此條目

Shen, G., Cheng, Y., & Tsai, L. (2005). Synthesis and characterization of Ni-P-CNT's nanocomposite film for MEMS applications. IEEE TRANSACTIONS ON NANOTECHNOLOGY, 4(5), 539–547. https://doi.org/10.1109/TNANO.2005.851397

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/13315