完整後設資料紀錄
DC 欄位 | 值 | 語言 |
---|---|---|
dc.contributor.author | Huang, Ching-Ying | en_US |
dc.contributor.author | Wu, Kun-Long | en_US |
dc.contributor.author | Hu, Robert | en_US |
dc.contributor.author | Chang, Chi-Yang | en_US |
dc.date.accessioned | 2019-08-02T02:18:26Z | - |
dc.date.available | 2019-08-02T02:18:26Z | - |
dc.date.issued | 2019-05-01 | en_US |
dc.identifier.issn | 1751-858X | en_US |
dc.identifier.uri | http://dx.doi.org/10.1049/iet-cds.2018.5269 | en_US |
dc.identifier.uri | http://hdl.handle.net/11536/152277 | - |
dc.description.abstract | This manuscript presents the design of a W-band receiver in which an radio frequency-low noise amplifier (RF-LNA), a wideband mixer, intermediate frequency (IF) amplification, a local oscillator frequency (LO) tripler and a driving amplifier are all integrated into one single chip of 1050 x 820 mu m(2). To effectively extend the mixer's IF bandwidth while retaining its conversion gain, impacts of the mixing transistor's drain bias and output loading impedance are explored using a dual-modulation conversion-matrix method, which allows both the LO-induced transconductance modulation and channel-conductance modulation to be considered simultaneously. It is shown that, by merging the input capacitance of the IF amplifier into a high-impedance artificial transmission line, an actively biased mixer can have constant conversion gain over broad bandwidth. A 77-110 GHz 65 nm-complementary metal-oxide-semiconductor (CMOS) receiver with 33 GHz IF bandwidth is then designed and measured. Its conversion gain and noise figure are 10 and 20 dB, respectively, and the input-referred P1 dB is -15 dBm; the overall power consumption is 330 mW under 1.3 V drain bias. | en_US |
dc.language.iso | en_US | en_US |
dc.subject | field effect MIMIC | en_US |
dc.subject | radio receivers | en_US |
dc.subject | CMOS integrated circuits | en_US |
dc.subject | millimetre wave receivers | en_US |
dc.subject | low noise amplifiers | en_US |
dc.subject | mixers (circuits) | en_US |
dc.subject | radioastronomical techniques | en_US |
dc.subject | W-band receiver | en_US |
dc.subject | RF-LNA | en_US |
dc.subject | wideband mixer | en_US |
dc.subject | LO tripler | en_US |
dc.subject | driving amplifier | en_US |
dc.subject | dual-modulation conversion-matrix method | en_US |
dc.subject | channel-conductance modulation | en_US |
dc.subject | IF amplifier | en_US |
dc.subject | high-impedance artificial transmission line | en_US |
dc.subject | actively biased mixer | en_US |
dc.subject | radio-astronomical receiver | en_US |
dc.subject | CMOS receiver | en_US |
dc.subject | wide-IF-band CMOS mixer | en_US |
dc.subject | IF amplification | en_US |
dc.subject | mixing transistor drain bias | en_US |
dc.subject | loading impedance | en_US |
dc.subject | LO-induced transconductance modulation | en_US |
dc.subject | frequency 77 | en_US |
dc.subject | 0 GHz to 110 | en_US |
dc.subject | 0 GHz | en_US |
dc.subject | size 65 | en_US |
dc.subject | 0 nm | en_US |
dc.subject | noise figure 20 | en_US |
dc.subject | 0 dB | en_US |
dc.subject | frequency 33 | en_US |
dc.subject | 0 GHz | en_US |
dc.subject | power 330 | en_US |
dc.subject | 0 mW | en_US |
dc.subject | voltage 1 | en_US |
dc.subject | 3 V | en_US |
dc.subject | gain 10 | en_US |
dc.subject | 0 dB | en_US |
dc.title | Analysis of wide-IF-band 65 nm-CMOS mixer for 77-110 GHz radio-astronomical receiver design | en_US |
dc.type | Article | en_US |
dc.identifier.doi | 10.1049/iet-cds.2018.5269 | en_US |
dc.identifier.journal | IET CIRCUITS DEVICES & SYSTEMS | en_US |
dc.citation.volume | 13 | en_US |
dc.citation.issue | 3 | en_US |
dc.citation.spage | 406 | en_US |
dc.citation.epage | 413 | en_US |
dc.contributor.department | 電子工程學系及電子研究所 | zh_TW |
dc.contributor.department | Department of Electronics Engineering and Institute of Electronics | en_US |
dc.identifier.wosnumber | WOS:000470680000019 | en_US |
dc.citation.woscount | 0 | en_US |
顯示於類別: | 期刊論文 |