Experimental Study on Thermal Contact Resistance Improvement for Optical Fiber by Using Low-Melting Temperature Alloy
檔案
本條目沒有附加檔案。
日期
2020-03-01
類型
系所
期刊名稱
JOURNAL OF ELECTRONIC PACKAGING
卷期與頁次
第 142 卷第 1 期
ISSN
1043-7398
語言
英文
摘要
This paper presents an experimental analysis for minimizing the thermal contact resistance (R) between an optical fiber and copper heat sink by using the low-melting temperature alloy (LMTA) as the thermal interface material (TIM) subject to high-flux operation (up to 250 W .m(-1)). For the cases without LMTA, the temperature rise (Delta T) can easily surpass 195 degrees C at a heating load of 25 W .m(-1). By contrast, Delta T is dramatically reduced to be less than 1 degrees C with LMTA as TIM with a much higher heating power of 150 W .m(-1). The corresponding thermal resistance (R) can be reduced from 6.5-8.2 K .m .W-1 to 0.004-0.013 K .m .W-1. The improvement is far superior to existing studies. Besides, decreasing the surface roughness and increasing contact pressure also help to reduce R, especially for the cases when the LMTA is not melted. As the LMTA melts, a significant reduction of R by 56% is achieved as compared to the case without melting. The effect of surface roughness and contact pressure on the thermal contact resistance is also examined, and it is found that the influences are small once LMTA melts.
關鍵詞
thermal contact resistancelow-melting temperature materialoptical fibercontact pressuresurface roughness所屬典藏
期刊論文引用此條目
Chu, W.-X., Lin, H.-Y., & Wang, C.-C. (2020). Experimental Study on Thermal Contact Resistance Improvement for Optical Fiber by Using Low-Melting Temperature Alloy. JOURNAL OF ELECTRONIC PACKAGING, 142(1), 0. https://doi.org/10.1115/1.4044774
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/153912