Design and fabrication of a three-dimensional long-stretch micro drive by electroplating

檔案

日期

2003

期刊名稱

SMART SENSORS, ACTUATORS, AND MEMS, PTS 1 AND 2

卷期與頁次

第 5116 卷,頁 295–302

ISSN

0277-786X

ISBN

0-8194-4976-8

語言

英文

摘要

Although lots of works have been devoted to develop the microactuators or microstructures, few researches have been done on three-dimensional microactuators. Here the feasibility investigation on a three-dimensional electrothermally driven long-stretch micro drive (LSMD) is proposed by integrating the LSMD and mechanical hinge mechanism. The LSMD (about 2000 mum x 500 mum) consists of two cascaded compliant structures in parallel. Each cascaded structure is formed by connecting several basic actuation units in series. The mechanical hinge is used to allow the LSMD to be lifted as a three-dimensional structure. One of the important issues in fabricating the three-dimensional microactuator is the conducting circuit to actuate the microactuator. Here the Ni electroplating process is used to fabricate the mechanical hinge structure and the LSMD, then the mechanical hinge itself can act as the conductive circuit easily. From the LSMD simulation results, several design parameters are found to have significant influence on the output displacements. Larger out-stretching displacements are feasible by proper choice of design parameters. Preliminary fabrication results of nickel-made LSMD exhibit output displacement of 190 mum at input voltage of 3 volts. Fabrication results of nickel-made three-dimensional LSMD are also presented.

所屬典藏

會議論文
顯示完整詮釋資料 統計資料

引用此條目

Wu, C., Tai, W., Hsu, C., & Hsu, W. (2003). Design and fabrication of a three-dimensional long-stretch micro drive by electroplating. SMART SENSORS, ACTUATORS, AND MEMS, PTS 1 AND 2, 5116, 295–302. https://doi.org/10.1117/12.498920

BibTeX RIS

引用文字依 APA 第 7 版格式自動產生,使用前請再核對。

分享

永久網址:https://ir.lib.nycu.edu.tw/handle/11536/18496