Single-crystal silicon nanostructure fabrication by scanning probe lithography and anisotropic wet etching
檔案
- 000174910000004.pdf (385.3 KB, Adobe PDF)
日期
2001
類型
系所
期刊名稱
DEVICE AND PROCESS TECHNOLOGIES FOR MEMS AND MICROELECTRONICS II
卷期與頁次
第 4592 卷,頁 34–42
ISSN
0277-786X
ISBN
0-8194-4322-0
語言
英文
摘要
Silicon nanostructures have been demonstrated by electric-field-enhanced localized oxidation on single crystal silicon wafer using a scanning probe microscope (SPM). In this study, we have demonstrated the use of scanning probe lithography (SPL) and orientation-dependent etching (ODE) can easily obtain nano-wire and nano-gap down to 24nm and 60nm on (110)-oriented silicon substrate. The scanning probe lithography (SPL) provides high resolution, which can be adjusted by tip bias, tip set force, scanning speed, and ambient humidity of environment, without damage in the substrate. The etching process employed the orientation-dependent etching (ODE), because of the etching rate of the (Ill)-plane is slower than any other crystallographic planes such that anisotropic etching profile can be obtained. The experimental samples were hydrogen-passivated by dipping in 10% aqueous HF solution to remove sample native oxide on the surface before SPM localized oxidation process. The SiOx nano-patterns on (110)-oriented silicon substrate were generated by SPM localized oxidation. Then, the etching process employed the ODE with a 34 wt.% aqueous KOH solution. The nano-wire feature size is easily down to 24nm and aspect ratio larger than 4:1. The optimization fine/space nanostructure is about 20 nm/80 nm and the nano-gap is about 60nm. In this study, we also have demonstrated the influence of etching temperature on the feature size of nanostructures with same aspect ratio. At the same etching depth (100nm), the line-width decreases with increasing the etching temperature. The theoretic etching rate and experimental etching rate are proportional to temperature, the higher temperature the higher etching rate.
關鍵詞
nanostructurescanning probe lithography (SPL)scanning probe microscope (SPM)localized oxidationOrientation-dependent etching (ODE)KOH wet etching所屬典藏
會議論文引用此條目
Chang, K., You, K., Wu, C., & Sheu, J. (2001). Single-crystal silicon nanostructure fabrication by scanning probe lithography and anisotropic wet etching. DEVICE AND PROCESS TECHNOLOGIES FOR MEMS AND MICROELECTRONICS II, 4592, 34–42. https://doi.org/10.1117/12.448972
引用文字依 APA 第 7 版格式自動產生,使用前請再核對。
分享
永久網址:https://ir.lib.nycu.edu.tw/handle/11536/18975