Title: 水泥與水泥/不飽和聚酯複合體固定化鉻之機制
Mechanisms of Solidification/Stabilization of Chromium with Cement and Cement/Unsaturated Polyester Composite
Authors: 林秋國
Lin, Chiou-Kuo
陳重男
林建中
Jong-Nan Chen
Chang-Cheng Lin
土木工程學系
Keywords: 水泥;鉻;固化;穩定化;不飽和聚酯;Cement;Chromium;Solidification;Stabilization;Unsaturated Polyester
Issue Date: 1996
Abstract:   對不同的廢棄物,尤其含重金屬之污泥,化學固定法被公認是最有效的處理技術之一
。水泥系固定化(S/S)程序具有使重金屬沈澱固化之作用,已被成功地應用在各種污泥固
化上。然依Arniella與Blythe (1990)研究指出,水泥固化體有10-5到10-9cm/sec的滲透
率,在Mindess與Young (1981)所著〝CONCRETE〞書中亦提到當水泥水化時會產生0.01到1
0(m大小的孔隙,這些孔隙形成通道,重金屬會藉此滲出,降低固定化效果。 本文研
究以水泥與水泥/不飽和聚酯複合體固定化含鉻污泥之反應機制。在水泥中加入不飽和聚
酯(UP)作固化體加強劑,使產生聚合或交聯作用,改善水泥滲透之缺點,提昇水泥系固定
化效果。使用的固化劑有水泥、水泥/不飽和聚酯及水泥單礦物((-C2S、C3S、C3A)。採用
的廢棄物有含鉻污泥、三氧化二鉻及硝酸鉻。應用掃描式電子顯微鏡(SEM)、X光能量散佈
儀(EDS)、X光繞射儀(XRD) 、固態核磁共振儀(29Si、27Al MAS/NMR)等精密儀器做結構及
分子分析,使用單軸抗壓強度(UCS)做巨觀分析,並運用毒物特性溶出程序(TCLP)做溶出
試驗。設計三個主要固定化反應程序,主要結論如下:一、水泥與水泥/不飽和聚酯複合
體固定化含鉻污泥之反應程序1. 水泥固定化含鉻污泥,其單軸抗壓強度大於10 Kg/cm2與
毒性物質溶出量皆符合我國衛生掩埋標準,但需分區獨立管理。2. 水泥/不飽和聚酯固
定化含鉻污泥,其單軸抗壓強度大於150 Kg/cm2與毒性物質溶出量大部份符合我國回收再
利用之條件。3. 水泥固化系試體之顯微結構呈現鬆散的組織;而水泥/不飽和聚酯固化
系試體之顯微結構呈現緊密的網狀組織。二、水泥或水泥/不飽和聚酯複合體固定化Cr2O3
或Cr(NO3)3 □9H2O之反應程序1. Cr2O3/Cement試體能形成CaCrO4結晶相,歸因於在水化
水泥產物中,Cr可能有取代Si的現象。2. 水泥固定化硝酸鉻,水泥水化程度會下降,而
水泥/不飽和聚酯固定化硝酸鉻,水化程度會明顯下降,表示硝酸鉻與不飽和聚酯皆會阻
礙水泥水化程度。三、水泥單礦物((-C2S、C3S、C3A)固定化Cr(NO3)3 □9H2O之反應機制
1. 水化(-C2S固定化硝酸鉻,會形成(-CaCrO4□2H2O新結晶相,表示Cr可能取代Si。2.
水化C3S固定化硝酸鉻,會形成CaCrSi4O10、CaCrO4 □2H2O及CaCr2O7三種新結晶相,表
示Cr可能取代Si。3. 水化C3A固定化硝酸鉻,會形成Al2(OH)4CrO4新結晶相,表示Cr與Al
會相互作用。
Chemical fixation/solidification of wastes is one of the best demonstrated a
vailable technologies for treating wastes, especially those containing heavy m
etals. Cement-based solidification/stabilization (S/S) processes have proven s
uccessful on many sludges generated by the precipitation of heavy metals.
Cement-based waste forms, however, typically have a permeability value rangin
g from 10-5 to 10-9 cm/sec. The capillary pores, which serve as a trans-portat
ion conduit, have sizes ranging from 0.01 to 10(m in the hydrated cementpaste,
thereby decreasing the effectiveness of solidification/stabilization. The p
resent study is to investigate the mechanisms of solidification/ stabilization
of chromium with cement and cement/unsaturated polyester com- posite. When un
saturated polyester (UP) is added as modification, the cement/ UP causes polym
erization or crosslinking, thus reducing the permeability of treated wastes an
d improving the effectiveness of solidification/stabili-zation of wastes. Th
e fixing agents used include cement, cement/UP and cement constituents (i.e. (
-C2S, C3S, and C3A). The wastes were chromium-containing sludge, chromic oxid
e (Cr2O3) and chromium nitrate (Cr(NO3)3 □9H2O). Scanning Elec-tron Microscop
y (SEM), Energy Dispe rsive Spectroscopy (EDS), X-ray Diff-raction (XRD) and M
agic Angle Spinning/Nuclear Magnetic Resonance (MAS/NMR ) were employed for th
e structural and molecular analysis of the solidified/stabilized samples. The
unconfined compressive strength (UCS) and the leach-ability by the Toxicity Ch
aracteristics Leaching Procedure (TCLP) of thesolidified/stabilized samples we
re measured. Three major S/S processes wereemployed in this study and some sig
nificant results are summarized as follows: I、Solidification/stabilization o
f chromium-containing sludge with cementand cement /unsaturated polyester comp
osite.1. All the solidified samples prepared with cement had compressive stren
gth higher than 10 Kg/cm2 and leachability values which met the Taiwan EPA re-
quirements for landfilldisposal. Nevertheless, they need to be disposed in se
gregated landfill.2. Most of the solidified samples prepared with cement/unsat
urated polyester composite had compressive strength higher than 150 Kg/cm2and
leachability values which met the Taiwan EPA requirements for recycle-reuse re
gulation.3. The samples prepared with cement exhibited loose structures,while
thosewith cement/unsaturated polyester composite exhibited denser structures i
n SEM observations.II、Solidification/stabilization of Cr2O3 or Cr(NO3)3 □9H2
O with cement and cement/unsaturated polyester composite. 1. Crystalline CaCr
O4 was formed during the S/S of Cr2O3 with cement.This isattributed to the sub
stitution of chromium for silicon in hydrated cementproducts.2. The degree of
cement hydration decreased during the S/S of Cr(NO3)3 □9H2O with cement, an
d it decreased more dramatically during the S/S of Cr(NO3)3 □9H2O with cement
/unsaturated polyester composite ; indicating that chromium nitrate an
d un saturated polyester could retard the extent of cement hydration.III、
Solidification/stabilization of Cr(NO3)3 □9H2O with cement constituents(i.e.
(-C2S, C3S, and C3A).1. Formation of (-calcium chromium oxide hydrate ((-CaCrO
4 □2H2O) during the solidification/stabilization of chromium nitrate (Cr(NO3)
3 □9H2O) with (-C2S indicates the probable replacement of silicon by chromium
in the calcium sili-cate hydrate (C-S-H). 2. Formation of calcium chromium si
licate (CaCrSi4O10),calcium chromium oxide hydrate (CaCrO4 □2H2O), and calciu
m dichromate (CaCr2O7) during the solidifi-cation/stabilization of chromium ni
trate (Cr(NO3)3 □9H2O) with C3S indicatesthe probable replacement of silicon
by chromium in the calcium silicate hydrate(C-S-H).3. Formation of aluminum ch
romium oxide hydroxide (Al2(OH)4CrO4) during thesolidification/stabilization o
f chromium nitrate (Cr(NO3)3 □9H2O) with C3Aindicates the probable interactio
n between Cr and Al.
URI: http://140.113.39.130/cdrfb3/record/nctu/#NT850015062
http://hdl.handle.net/11536/61436
Appears in Collections:Thesis